Quartz and Hematite Activation by Zn, Ca and Mg Ions in the Cationic Flotation Route for Oxidized Zinc Ore

Geraldo Magela Pereira Duarte,Rosa Malena Fernandes Lima
DOI: https://doi.org/10.1080/08827508.2021.1931175
2021-05-25
Mineral Processing and Extractive Metallurgy Review
Abstract:<span>Anionic, cationic and cationic/anionic flotation is widely used in the concentration process for low-grade oxidized zinc ores. In the cationic flotation route, sodium silicate is used as a depressant for gangue minerals and amine as a collector for zinc minerals previously activated by sodium sulfide. However, the presence of polyvalent ions in aqueous solution can affect the surface properties of the various minerals and consequently, the selectivity of the process. This study evaluated the effect of Zn, Ca, and Mg ions, originated by the solubility of smithsonite and dolomite, on the surface properties of quartz and hematite. Microflotation tests showed the inefficiency of sodium silicate as a depressant for quartz in aqueous solution even when Zn, Ca, and Mg ions were not present. Activation of hematite by Zn ions was observed, impeding the separation of smithsonite and hematite (iron oxide). Results obtained from the microflotation and zeta potential tests were analyzed based on the speciation diagrams of the reagents and ions studied, as well as published studies.</span>
metallurgy & metallurgical engineering,mining & mineral processing
What problem does this paper attempt to address?