The Gas Production Characteristics of No. 3 Coal Seam Coalbed Methane Well in the Zhengbei Block and the Optimization of Favorable Development Areas
Cong Zhang,Qiujia Hu,Chunchun Liu,Huimin Jia,Guangjie Sang,Dingquan Wu,Kexin Li,Qian Wang
DOI: https://doi.org/10.3390/pr12092018
IF: 3.5
2024-09-20
Processes
Abstract:The characteristics and influencing factors of gas production in CBM wells are analyzed based on the field geological data and the productivity data of coalbed methane (CBM) wells in the Zhengbei block, and then the favorable areas are divided. The results show that the average gas production of No. 3 coal seam CBM wells in the study area is in the range of 0~1793 m3/d, with an average of 250.97 m3/d; 80% of the wells are less than 500 m3/d, and there are fewer wells above 1000 m3/d. The average gas production is positively correlated with gas content, critical desorption pressure, permeability, Young's modulus, and Schlumberger ratio, and negatively correlated with fracture index, fault fractal dimension, Poisson's ratio, and horizontal stress difference coefficient. The relationship between coal seam thickness and the minimum horizontal principal stress is not strong. The low-yield wells have the characteristics of multiple pump-stopping disturbances, unstable casing pressure control, overly rapid pressure reduction in the single-phase flow stage, sand and pulverized coal production, and high-yield water in the later stage during the drainage process. It may be caused by the small difference in compressive strength between the roof and floor and the coal seam, and the small difference in the Young's modulus of the floor. The difference between the two high-yield wells is large, and the fracturing cracks are easily controlled in the coal seam and extend along the level. The production control factors from strong to weak are as follows: critical desorption pressure, permeability, Schlumberger ratio, fault fractal dimension, Young's modulus, horizontal stress difference coefficient, minimum horizontal principal stress, gas content, Poisson's ratio, fracture index, coal seam thickness. The type I development unit (development of favorable areas) of the Zhengbei block is interspersed with the north and south of the block on the plane, and the III development unit is mainly located in the east of the block and near the Z-56 well. The comprehensive index has a significant positive correlation with the gas production, and the prediction results are accurate.
engineering, chemical