Abstract:The post-flame oxidation rate of ammonia was investigated in a novel atmospheric pressure flow reactor at temperatures of 1280 ± 16 K and as a function of residence time and mixture composition (1-10% O 2 , dry and moist). The experimental results, as well as selected data from literature, were analyzed using an updated detailed chemical kinetic model. The medium temperature, very lean conditions enhance the importance of reactions of the nitroxyl (HNO) intermediate. High-level theory was used to calculate the rate constant for HNO + NH 2 , indicating that this step is significantly faster than values used in literature. Furthermore, a trajectory based approach was used to determine collision efficiencies for selected bath gases for HNO + M. The experimental results show that the NH 3 oxidation rate increases with temperature and O 2 concentration, while the presence of water vapor slightly inhibits reaction. Formation of NO and N 2 O was strongly promoted at higher levels of O 2 . Modeling results agreed well with the measurements, except at the lowest level of O 2 . The predicted oxidation rate of NH 3 was shown to result from a delicate balance between chain branching and terminating steps involving NH 2 , H 2 NO, and HNO. Recent theoretical work on reactions of these species by Klippenstein and coworkers and Stagni et al. was instrumental in improving modeling predictions. After initiation, NO reached a pseudo-steady-state level, where the pathways to NO were largely balanced by the NH 2 + NO reaction. Nitric oxide was partly oxidized to NO 2 , with the NH 2 + NO 2 reaction responsible for most of the N 2 O formation. Novelty and significance statement: This study provides the first detailed kinetic analysis of the lean post-flame oxidation of ammonia, based on time-resolved flow reactor data in a novel reactor. In addition to the post-flame oxidation rate of ammonia, data for formation of NO and N 2 O were compared with modeling predictions. The medium temperature, very lean conditions enhance the importance of reactions of the HNO and H 2 NO intermediates. Inclusion in the model of results from recent high-level theoretical work, including present calculations for HNO + NH 2 and HNO + M, was crucial for capturing the observed behavior. It is argued that the post-initiation steady-state NH 3 oxidation rates constitute important data for model validation, along with ignition delays and laminar flame speeds.

An interpretation of the high-pressure kinetics of ammonia synthesis based on a microscopic model

Reaction Kinetics for Ammonia Synthesis using Ruthenium and Iron based Catalysts under Low Temperature and Pressure Conditions

Reaction−Diffusion Model for Irregularly Shaped Ammonia Synthesis Catalyst and Its Verification under High Pressure

Experimental and Kinetic Study of Ammonia Oxidation and NOx Emissions at Elevated Pressures

Ammonia synthesis rate over a wide operating range: from experiments to validated kinetic models

Theoretical Kinetics Predictions for Reactions on the NH2O Potential Energy Surface

Experimental and Modeling High-Pressure Study of Ammonia–Methane Oxidation in a Flow Reactor

Reaction Mechanism and Kinetics for Ammonia Synthesis on the Fe(111) Surface

Intrinsic Kinetics of A301 Ammonia Synthesis Catalyst

High pressure oxidation of NH 3 / n -heptane mixtures

An experimental, theoretical, and kinetic modeling study of post-flame oxidation of ammonia

Enhancement of the Ammonia Kinetic Mechanism for Nitrogen-Based Pollutant Chemistry

An Experimental and Kinetic Modelling Study on the Oxidation of NH3, NH3/H2, NH3/CH4 in a Variable Pressure Laminar Flow Reactor at Engine-Relevant Conditions

Kinetic Modeling Analysis of Ar Addition to Atmospheric Pressure N2-H2 Plasma for Plasma-Assisted Catalytic Synthesis of NH3

Pressure-Dependent Kinetic Analysis of the N2H3 Potential Energy Surface

Analysis of methane pyrolysis experiments at high pressure using available reactor models

Conformity of macroscopic behavior to local properties in the catalytic ammonia synthesis and oscillatory reactions on metal surfaces

Selected Reactive Sites Tuned by High Pressure: Oligomerization of Solid-State Cyanamide

Experimental and Modeling Study for the Effect of Methanol Blending on Ammonia Oxidation and NOx Formation at High Pressure

A comprehensive analysis of ammonia synthesis over a commercial iron-based catalyst using differential and integral reactor models

Kinetic Modeling of the Thermal Decomposition of Ammonia