Effect of Flame Retardant Additives on the Flammability and Flame Spread Rate of Glass-Fiber-Reinforced Epoxy Resin with Varying Binder Content: An Experimental and Numerical Study
S. A. Trubachev,E. A. Sosnin,A. I. Karpov,A. A. Paletsky,O. P. Korobeinichev,A. A. Shaklein,A. R. Sagitov,A. G. Shmakov,I. V. Kulikov,O. O. Tuzhikov,B. A. Buravov
DOI: https://doi.org/10.1080/00102202.2024.2391504
IF: 1.9
2024-08-23
Combustion Science and Technology
Abstract:This paper presents a study of flammability and downward flame spread rate in an opposed oxidizer flow over glass fiber-reinforced epoxy resin (GFRER) with the added flame retardants 6,6′-((methylenebis(4,1-phenylene))bis(azanediyl)) bis(6 H-dibenzo[c,e][1,2]oxaphosphinine 6-oxide) (DDM-DOPO) and graphene and with a binder content (BC) of ~ 35 wt% and ~ 52 wt%; the mass ratio of the glass fiber to the binder in the composite was 2:1 and 1:1, respectively. To evaluate the flammability and thermal stability of the obtained materials, the LOI test, the UL-94HB test, and thermogravimetric analysis were conducted. The effective DDM-DOPO concentration for decreasing the flammability of GFRER was found based on the LOI results. During the flame spread experiment with an opposed oxidizer flow, the addition of flame retardants resulted in an increase in the limiting oxygen concentration (LOC). Oxygen concentration increase in the oxidizer flow led to a decrease in the flame retardant effect on the rate of flame spread (ROS) for samples with a BC of ~ 35 wt%. The flame retardant effectiveness for samples with a BC of ~ 52 wt% remained almost the same at 40–60 vol% O 2 concentrations. The relationship among the LOI, LOC, and ROS was experimentally established. A numerical simulation of flame spread over reinforced material was performed using a coupled gas-solid heat and mass transfer model to predict the ROS over GFRER with and without flame retardants. The model correctly predicted the ROS for GFRER with ~ 35 wt% BC, while for samples with ~ 52 wt% BC, the model gave lower ROS compared to experiment.
energy & fuels,engineering, chemical,thermodynamics, multidisciplinary