Abstract:The parallel mechanism was adopted as seat suspension system in this paper. And the active joints with damping springs as the reduction vibration actuator, the reduction vibration seat model with 3-PRPS parallel mechanism which had six degree of freedom was established. With position of the mechanism as the premise, stability indexes of the reduction vibration seat in motion were proposed. As a result, the task space of the moving platform was obtained according to the inverse solution of the mechanism position. To reduce vibration effectively, velocity matrix of branched chain was built by means of vector method. The structural parameters were obtained by the numerical computation to improve the reduction vibration space and flexibility. Based on the above analysis, the simulation model can be obtained. In order to verify the reliability of the simulation model, the experiment of vibration acceleration transmissibility was conducted and the result was then compared with that of the numerical computation. Their results were consistent with each other. It indicated that the simulation model was reliable and could be used for the subsequent analysis. Then, influence factors of vibration acceleration transmissibility were researched based on the verified simulation model. In order to obtain a suspension system with better reduction vibration performance, making the maximum vibration acceleration transmissibility in the vertical and horizontal be minimal was set as the optimization objective. And the above influence factors were taken as the design variables. Finally, the ride comfort of vehicles was improved. Meanwhile, this research can also provide some references for the similar engineering problems.

Vibration reduction performance of an innovative vehicle seat with a vibration absorber and variable damping cushion

Adaptive control of a vehicle-seat-human coupled model using quasi-zero-stiffness vibration isolator as seat suspension

Effect of delayed resonator on the vibration reduction performance of vehicle active seat suspension

Research on Vibration Isolation System with Variable Stiffness and Damping for a Vehicle Seat

Investigation of a seat suspension installed with compact variable stiffness and damping rotary magnetorheological dampers

Semi-Active Vibration Control of Seat Suspension Equipped with a Variable Equivalent Inertance-Variable Damping Device

Ride Comfort Analysis of Seated Occupants Based on an Integrated Vehicle-Human Dynamic Model

Vibrational comfort improvement for a passenger car driver seat

Study on Vibration Damping of Vehicle Seat Suspension Based on MR Technology

Performance evaluation of a novel semi-active absorption and isolation co-control strategy with magnetorheological seat suspension for commercial vehicle

Prescribed Performance Control-Based Semi-Active Vibration Controller for Seat Suspension Equipped with an Electromagnetic Damper

Effect of time-delay feedback control on vehicle seat vibration reduction and suspension performance

Development of a New Seating Platform Based on the 3-RCC Parallel Mechanism

MRD Modeling and Its Application in Seat Cushioning

Numerical optimization of vibration acceleration transmissibility for seat suspension system in vehicles

Multi-dimensional vibration isolating properties of a 3-RPS parallel damping seat

Modelling and Validation of a Seat Suspension with Rubber Spring for Off-Road Vehicles

An Energy Saving Variable Damping Seat Suspension System With Regeneration Capability

Transmission of Vertical Vibration Through a Seat Cushion at the Seat Pan: Effect of Foam Physical Properties During Different Excitation Magnitudes

Study and Optimization on Vibration Transfer Characteristics of Commercial Vehicle Seats

Improvement of Commercial Vehicle Seat Suspension Employing a Mechatronic Inerter Element