Abstract:Miniaturization of gas chromatography (GC) instrumentation is of interest because it addresses current and future issues relating to compactness, portability and field application. While incremental advancements continue to be reported in GC with columns fabricated in microchips (referred to in this paper as "microchip columns"), the current performance is far from acceptable. This lower performance compared to conventional GC is due to factors such as pooling of the stationary phase in corners of non-cylindrical channels, adsorption of sensitive compounds on incompletely deactivated surfaces, shorter column lengths and less than optimum interfacing to injector and detector. In this work, a GC system utilizing microchip columns was developed that solves the latter challenge, i.e., microchip interfacing to injector and detector. A microchip compression clamp was constructed to heat the microchip (i.e., primary heater), and seal the injector and detector fused silica interface tubing to the inlet and outlet ports of the microchip channels with minimum extra-column dead volume. This clamp allowed occasional operation up to 375°C and routine operation up to 300°C. The compression clamp was constructed of a low expansion alloy, Kovar™, to minimize leaking due to thermal expansion mismatch at the interface during repeated thermal cycling, and it was tested over several months for more than one hundred injections without forming leaks. A 5.9m long microcolumn with rectangular cross section of 158μm×80μm, which approximately matches a 100μm i.d. cylindrical fused silica column, was fabricated in a silicon wafer using deep reactive ion etching (DRIE) and high temperature fusion bonding; finally, the channel was coated statically with a 1% vinyl, 5% phenyl, 94% methylpolysiloxane stationary phase. High temperature separations of C10-C40 n-alkanes and a commercial diesel sample were demonstrated using the system under both temperature programmed GC (TPGC) and thermal gradient GC (TGGC) conditions. TGGC analysis of a complex essential oil sample was also demonstrated. Addition of a secondary heater and polyimide insulation proved to be helpful in achieving the desired elution temperature without having to raise the primary heater temperature above 300°C for high boiling point compounds.

Automatic simulated distillation of heavy petroleum fractions up to 800°C TBP by capillary gas chromatography. Part I: Possibilities and limits of the method

Determination of boiling point distribution by TG using a novel crucible and comparison with true boiling point distillation and simulated distillation by GC–MS and Py-GC/MS

High-Temperature Simulated Distillation Gc Analysis Of Petroleum Resids And Their Products From Catalytic Upgrading Over Co-Mo/Al2o3 Catalyst

Study on Purification of Pyrolytic Oil Derived from Pilot-scale Pyrolysis of Waste Tires in Multilevel Reactor

Quantitative Analysis Using Directly Coupled Supercritical Fluid Extraction-Capillary Gas Chromatography (SFE-GC) With a Conventional Split/Splitless Injection Port

Simultaneous determination of major characteristic parameters of naphtha by capillary gas chromatography

Comparison of TG-MS and GC-simulated distillation for determination of the boiling point distribution of various oils

Absorption and desorption of gaseous toluene by an absorbent microcapsules column.

Thermal Cracking of Oil under Water Pressure up to 900 Bar at High Thermal Maturities: 2. Insight from Light Hydrocarbon Generation and Carbon Isotope Fractionation

Material Characterization Using a Tandem Micro-Reactor – GC–MS

Simulated Distillation of Coal Tar

Evaluation of the Performance of Cryogen-Free Thermal Modulation-Based Comprehensive Two-Dimensional Gas Chromatography-Time-of-Flight Mass Spectrometry (GC×GC-TOFMS) for the Qualitative Analysis of a Complex Bitumen Sample

Liquid Paraffin As New Dilution Medium for the Analysis of High Boiling Point Residual Solvents with Static Headspace-Gas Chromatography.

Experimental Analysis of Fischer-Tropsch Synthesis Product Distribution

Extending the upper temperature range of gas chromatography with all-silicon microchip columns using a heater/clamp assembly

Separation of BTX chemicals from biomass pyrolysis oils via continuous flash distillation

Thermogravimetric Analysis of Fuel Film Evaporation

High-Temperature Simulated Distillation Study on Catalytic Upgrading of Atmospheric and Vacuum Resids.

Comprehensive two-dimensional liquid chromatography with inductively coupled plasma mass spectrometry detection for the characterization of sulfur, vanadium and nickel compounds in petroleum products

Determination of Unsaturated Hydrocarbons in Oil and Its Processing Products by Capillary Gas Chromatography and High-Performance Liquid Chromatography

On Fractioning the Tire Pyrolysis Oil in a Pilot-Scale Distillation Plant under Industrially Relevant Conditions