Abstract:At ultralow shear rate (~0.01 s−1), acting below the yield stress of the aqueous gel, adsorption of calcium carbonate nanoparticles (<~100 nm) onto cellulose nanofibrils is induced without pigment–pigment preflocculation. Dispersant-free and polyacrylate treated dispersed carbonate particles are compared. Initially, it is seen that the polyacrylate dispersed material does not adsorb, whereas the dispersant-free carbonate adsorbs readily under the controlled ultralow shear conditions. However, repeated cycles of ultralow shear with intermittent periods in the rest state eventually induce the effect as initially seen with the dispersant-free calcium carbonate. The fibril suspension in the bulk is slightly acidic. The addition of buffer to a controlled pH in the case of the dispersant treated particles maintained a similar delay in the onset of adsorption, but adsorption occurred eventually after repeated cycles. During this cycling process, in parallel, the pH gradually drops under repeated cycles of ultralow shear, opposite to expectation, given the buffering capacity of calcium carbonate. The conductivity, in turn, progressively increases slightly at first and then significantly. The action of surface bound water on the nanofibril is considered key to the action of adsorption, and the condition of ultralow shear suggests that the residence time of the particle in contact with the nanofibril, acting under controlled strain against diffusion in the gel, is critical. It is proposed that under these specific conditions the calcium carbonate nanoparticles act as a probe of the nanofibril surface chemistry. The hydrogen bonded water, known to reside at the nanofibril surface, is thus considered the agent in the carbonate-surface interaction, effectively expressing an acid dissociation, and the calcium carbonate nanoparticles act as the probe to reveal it. An important phenomenon associated with this acid dissociation behaviour is that the adsorbed calcium carbonate particles subsequently act to flocculate the otherwise stable cellulose material, leading to release of water held in the aqueous gel matrix structure. This latter effect has major implications for the industrial ease of use of micro and nanofibrillar cellulose at increased solids content. This novel mechanism is also proposed for use to enhance the dewatering capability in general of complex cellulose-containing gel-like water-holding suspensions.

Simplification of gel point characterization of cellulose nano and microfiber suspensions

Gel point as a measure of cellulose nanofibre quality and feedstock development with mechanical energy

Estimation of cellulose nanofibre aspect ratio from measurements of fibre suspension gel point

Isolation and rheological characterization of cellulose nanofibrils (CNFs) produced by microfluidic homogenization, ball-milling, grinding and refining

Rheological properties of nanocellulose suspensions: effects of fibril/particle dimensions and surface characteristics

Rapid cellulose nanomaterial characterisation by rheology

Confocal analysis of cellulose nanocrystal (CNC) based hydrogels and suspensions

Low temperature effects on the rheological properties of aqueous cellulose nanofiber suspensions

Investigating the impact of cellulose microgel nanofabrication on the rheological properties of this binary rheology modifier

Morphological and Rheological Properties of Cellulose Nanofibrils Prepared by Post-Fibrillation Endoglucanase Treatment

Rheology of cellulose nanocrystal and nanofibril suspensions

Structure-property relations in rheology of cellulose nanofibrils-based hydrogels

Acid dissociation of surface bound water on cellulose nanofibrils in aqueous micro nanofibrillated cellulose (MNFC) gel revealed by adsorption of calcium carbonate nanoparticles under the application of ultralow shear

Synthesis and characterization of nanocelluloses isolated through acidic hydrolysis and steam explosion of Gliricidia sepium plant fiber

Rheology of cellulose nanofibers suspensions: Boundary driven flow

Rheology of Suspensions of TEMPO-Oxidised and Cationic Cellulose Nanofibrils—The Effect of Chemical Pre-Treatment

Using Rheology and Image Processing to Study the Effects of Cellulose Nanocrystal Sedimentation

Rheological Aspects of Cellulose Nanomaterials: Governing Factors and Emerging Applications

Critical-like gelation dynamics in cellulose nanocrystal suspensions

Preparation and thermal stability evaluation of cellulose nanofibrils from bagasse pulp with differing hemicelluloses contents

Preparation and characterization of sulfated nanocellulose: From hydrogels to highly transparent films