Abstract:Purpose: This work describes the hardware and software developments of a prototype chest digital tomosynthesis (CDT) R/F system. The purpose of this study was to validate the developed system for its possible clinical application on low-dose chest tomosynthesis imaging. Methods: The prototype CDT R/F system was operated by carefully controlling the electromechanical subsystems through a synchronized interface. Once a command signal was delivered by the user, a tomosynthesis sweep started to acquire 81 projection views (PVs) in a limited angular range of ±20°. Among the full projection dataset of 81 images, several sets of 21 (quarter view) and 41 (half view) images with equally spaced angle steps were selected to represent a sparse view condition. GPU-accelerated and total-variation (TV) regularization strategy-based compressed sensing (CS) image reconstruction was implemented. The imaged objects were a flat-field using a copper filter to measure the noise power spectrum (NPS), a Catphan® CTP682 quality assurance (QA) phantom to measure a task-based modulation transfer function (MTFTask ) of three different cylinders' edge, and an anthropomorphic chest phantom with inserted lung nodules. The authors also verified the accelerated computing power over CPU programming by checking the elapsed time required for the CS method. The resultant absorbed and effective doses that were delivered to the chest phantom from two-view digital radiographic projections, helical computed tomography (CT), and the prototype CDT system were compared. Results: The prototype CDT system was successfully operated, showing little geometric error with fast rise and fall times of R/F x-ray pulse less than 2 and 10 ms, respectively. The in-plane NPS presented essential symmetric patterns as predicted by the central slice theorem. The NPS images from 21 PVs were provided quite different pattern against 41 and 81 PVs due to aliased noise. The voxel variance values which summed all NPS intensities were inversely proportional to the number of PVs, and the CS method gave much lower voxel variance by the factors of 3.97-6.43 and 2.28-3.36 compared to filtered backprojection (FBP) and 20 iterations of simultaneous algebraic reconstruction technique (SART). The spatial frequencies of the f50 at which the MTFTask reduced to 50% were 1.50, 1.55, and 1.67 cycles/mm for FBP, SART, and CS methods, respectively, in the case of Bone 20% cylinder using 41 views. A variety of ranges of TV reconstruction parameters were implemented during the CS method and we could observe that the NPS and MTFTask preserved best when the regularization and TV smoothing parameters α and τ were in a range of 0.001-0.1. For the chest phantom data, the signal difference to noise ratios (SDNRs) were higher in the proposed CS scheme images than in the FBP and SART, showing the enhanced rate of 1.05-1.43 for half view imaging. The total averaged reconstruction time during 20 iterations of the CS scheme was 124.68 s, which could match-up a clinically feasible time (<3 min). This computing time represented an enhanced speed 386 times greater than CPU programming. The total amounts of estimated effective doses were 0.12, 0.53 (half view), and 2.56 mSv for two-view radiographs, the prototype CDT system, and helical CT, respectively, showing 4.49 times higher than conventional radiography and 4.83 times lower than a CT exam, respectively. Conclusions: The current work describes the development and performance assessment of both hardware and software for tomosynthesis applications. The authors observed reasonable outcomes by showing a potential for low-dose application in CDT imaging using GPU acceleration.

Optimization of a customized simultaneous algebraic reconstruction technique algorithm for phase-contrast breast computed tomography

Comparison of three reconstruction algorithms for low-dose phase-contrast computed tomography of the breast with synchrotron radiation

Optimization-Based Image Reconstruction from Low-Dose Patient Breast Ct Data

Optimization methods for very accurate Digital Breast Tomosynthesis image reconstruction

Imaging study of a phase-sensitive breast-CT system in continuous acquisition mode

Stationary Digital Breast Tomosynthesis System That Uses a Carbon Nanotube X-ray Source Array: a Feasibility Study

Variable step size methods for solving simultaneous algebraic reconstruction technique (SART)-type cbct reconstructions

A Preliminary Study Of Image Reconstruction From Low-Dose Data In Dedicated Breast Ct

Weighted simultaneous algebraic reconstruction technique for tomosynthesis imaging of objects with high-attenuation features

Optimization-based image reconstruction with artifact reduction in C-arm CBCT.

Evaluation of Hybrid SART + OS + TV Iterative Reconstruction Algorithm for Optical-Ct Gel Dosimeter Imaging

SU‐E‐I‐38: Constrained ‐ Total ‐ Variation ‐ Minimization ‐ Based Image Reconstruction in Breast CT

Development of a chest digital tomosynthesis R/F system and implementation of low-dose GPU-accelerated compressed sensing (CS) image reconstruction

An Iterative Image Reconstruction Algorithm Combined with Forward and Backward Diffusion Filtering for In-Line X-ray Phase-Contrast Computed Tomography

Statistical Iterative Reconstruction Using Fast Optimization Transfer Algorithm with Successively Increasing Factor in Digital Breast Tomosynthesis

Investigation of Iterative Image Reconstruction in Low-Dose Breast CT

Optimization-based Reconstruction for Reduction of CBCT Artifact in IGRT

Iterative phase contrast CT reconstruction with novel tomographic operator and data-driven prior

Optimization of reconstruction time of ultrasound computed tomography with a piecewise homogeneous region-based refract-ray model

Image reconstruction and scan configurations enabled by optimization-based algorithms in multispectral CT

SART Algorithm Parallel Implementation with Siddon and MBR Methods for Digital Linear Tomosynthesis Using OpenCL