Abstract:In order to study the anti-freeze performance of concrete,respectively making two group of different specimens which were plain concrete blocks and reinforced concrete columns.The two groups of specimens were designed into four different materials,according to the water cement ratio and dosage of fly ash.They were also tested under freeze-thaw cycle of different numbers as 0,20,40,60,100 and 120 to study the antifreeze performance of plain concrete and reinforced concrete,also with contrast.As the first part,this paper mainly described the antifreeze performance of confined concrete,analyzing degradation rule of strength and stiffness of confined concrete with freeze-thaw cycles and the impact of different ratio of materials on the antifreeze performance of specimens.Research shows that in 0~120 times freeze-thaw cycle,with the increase of freeze-thaw cycles,ultimate strength of confined concrete was steeply falling in the early cycle,gently in mid freeze-thaw cycle and again sharply fall in the last stages,the curve of ultimate strength had a platform,at the freeze-thaw cycle of 120 times,ultimate bearing capacity reduced about 50%,but the ductility relatively increase 2~3 cycles.As the same water-cement ratio,the ultimate bearing capacity of 15% fly ash confined concrete column less than the concrete columns without mixing fly ash,reducing about 30%~50%,so mixing 15% fly ash does not improve anti-freeze performance;as the same dosage of fly ash,the higher the water-cement ratio,the greater the ultimate bearing capacity;concerte with no fly ash should use low water cement ratio.In this paper,we study the bearing capacity of reinforced concrete structures in cold areas subjected to freezing and thawing,which has an important guiding significance to the evaluation and design of confined concrete.

The Influence of Fair-Faced Concrete Protective Agent on the Resistance to Freezing and Thawing of Concrete

Effect of imitation fair-faced curing and protective coating on the durability of concrete

Effects of Polyurethane Coating on Concrete Freezing Resistance

Environmental Factors Influencing The Durability Of Concrete Structures In Frost Environments

Effect of PVA fiber on the freezing and thawing behavior of concrete

Experimental Study and Mechanism Analysis on Frost Resistance of Normal Performance Concrete under Different Environments

Behavior of PVA fiber concrete under freezing and thawing cycles

XYPEX Concentrates on the Impact of Frost Resistance of Concrete

Experiment on Freeze–Thaw Resistance of Tunnel Portal-Lining Concrete with Silicone Coating in Cold Regions

Effect of Graphene Oxide and Fly Ash on Frost Resistance of the Steel Fiber Reinforced Concrete

Influence of Combined Air-Entraining Superplasticizer and Surface Treatments on Airport Pavement Concrete Against Salt Freezing

Influence of silane treatment on the freeze-thaw resistance of concrete

Experimental Study on Basic Properties of Fair-Faced Concrete for Urban Bridge

The Influence of Freeze–Thaw Cycles and Corrosion on Reinforced Concrete and the Relationship between the Evolutions of the Microstructure and Mechanical Properties

Experimental investigation on anti-freeze behavior of confined concrete

Chloride ion penetration resistance of concrete containing fly ash and silica fume against combined freezing-thawing and chloride attack

Test on Effect of Complex Admixture to the Concrete Frost Resistance

Influence to frost-resistant performance of concrete in stress state

Study on the Frost Resistance of Composite Limestone Powder Concrete against Coupling Effects of Sulfate Freeze–Thaw

Effect of Saturation Degree on Concrete Deterioration Due to Freeze-Thaw Action

The Influence of Metakaolin and Polypropylene Fiber Concrete on Mechanics Properties and Microstructure Combined Action under Multi-Salt Soaking and Freeze–Thaw