Abstract:Conventional vehicle electronic stability control requires one steering-wheel angle sensor, one lateral acceleration sensor and one yaw rate sensor to obtain a good control performance. The control system stops working when a sensor fault is detected, which means that the vehicle runs in an unprotected state. Thus, various sensor fault diagnosis algorithms have been designed to detect and isolate the faulty sensor, but these algorithms also can be used for fault-tolerant control to preserve the safety of the vehicle. However, determining which of the different sensors is faulty is very difficult as the conventional residual comparison algorithm can only find the existence of a sensor fault but cannot locate the faulty sensor, and very few research studies have focused on this problem. In this paper, an ingenious sensor fault diagnosis algorithm is proposed. The sensor fault is detected, located and isolated by cross-checking with three different yaw rate estimates. The steering-wheel angle observer and the lateral acceleration observer are designed to provide corresponding estimated sensor signals which are employed to estimate the different yaw rates by using an extended Kalman filter. A novel decision-making process is carefully designed to locate the faulty sensor based on the different yaw rate residuals. Electronic stability control is not interrupted as the faulty sensor signal is reconfigured by the estimated signal. Experimental tests on a real car show that the proposed algorithm is efficient for detecting the sensor fault and identifying which sensor is faulty. Simulations show that the vehicle stability control strategy based on the proposed sensor fault-tolerant control algorithm has a better performance than the traditional control strategy does.

A data‐driven sensor fault‐tolerant control scheme based on subspace identification

Fault Diagnosis and Reconfigurable Control for Underwater Vehicles

Adaptive Sensor-Fault Tolerant Control of Unmanned Underwater Vehicles With Input Saturation

Data-driven sensor fault diagnosis systems for linear feedback control loops

Model-based Sensor Fault Detection and Isolation Method for a Vehicle Dynamics Control System

Data‐driven fault‐tolerant control for SISO nonlinear system with unknown sensor fault

Data-Driven Optimal Fault-Tolerant Control for Unknown Linear Systems

Sensor-Fault-Tolerant Operation for the Independent Metering Control System

Virtual-Sensor-Based Model-Free Adaptive Fault-Tolerant Constrained Control for Discrete-Time Nonlinear Systems

Fault Tolerant Control in Underwater Vehicles

A data‐driven distributed fault detection scheme based on subspace identification technique for dynamic systems

Adaptive fault identification and reconfigurable fault‐tolerant control for unmanned surface vehicle with actuator magnitude and rate faults

A Hybrid Model-Data Vehicle Sensor and Actuator Fault Detection and Diagnosis System

Adaptive fixed‐time dynamic surface fault‐tolerant control of nonlinear systems with sensor faults

A Dynamic Scaling Based Adaptive Fault-tolerant Control Scheme for Rigid Spacecraft with Simultaneous Sensor and Actuator Faults

Active Fault-Tolerant Control for a Class of Nonlinear Systems with Sensor Faults

A Novel Fault Detection, Identification and Prediction Approach for Autonomous Vehicle Controllers Using SVM

Active Fault-Tolerant Control Framework for Linear Parameter-Varying Systems Affected by Sensor Faults

Fault-Tolerant Control Based on Current Space Vectors against Total Sensor Failures

Sensor fault detection and compensation with performance prescription for robotic manipulators

Sensor faults compensation for MIMO fault-tolerant control systems