Abstract:The occurrence of sulfur in coal direct liquefaction residue affects its further high quality and high value utilization. Electrochemical desulfurization is characterized by mild reaction conditions, simple operation, easy separation of sulfur conversion products and little influence on the properties of the liquefied residue. An anodic electrolytic oxidation desulphurization experiment was carried out on the liquefaction residue of the by-product of a coal-to-liquid enterprise in the slurry state. An electrochemical test and material characterization of raw materials before and after electrolysis showed that electrolytic oxidation can desulfurize the liquefaction residue under an alkaline condition. Linear sweep voltammetry (LSV) was used for the electrolysis experiments to obtain the optimal slurry concentration of 60 g/L. On this basis, the reaction kinetics were calculated, and the minimum activation energy in the interval at 0.9 (V vs. Hg/HgO) was 19.71 kJ/mol. The relationship between the electrolytic desulfurization of the liquefied residue and energy consumption was studied by the potentiostatic method. The influence of anodic potential and electrolytic temperature on the current density, cell voltage, desulfurization rate and energy consumption was investigated. The experimental results showed that the desulfurization rate and total energy consumption increase positively with the increase in reaction temperature and electrolytic potential in a certain range. The influence of the reaction temperature on the desulfurization rate and total energy consumption is more prominent than that of electrolytic potential, but the energy consumption of sulfur removal per unit mass does not show a positive correlation. Therefore, with the energy consumption per unit mass of sulfur removal as the efficiency index, the optimal experimental results were obtained: under the conditions of 0.8 (V vs. Hg/HgO) anode potential, 50 °C electrolytic temperature, 60 g/L slurry concentration and 14,400 s electrolytic time, the desulfurization rate was 18.85%, and the power consumption per unit mass of sulfur removal was 5585.74 W·s/g. The results of XPS, SEM, BET and IC showed that both inorganic and organic sulfur were removed by electrolytic oxidation, and the morphology, pore structure and chemical bond of the liquefied residue were affected by electrolytic oxidation. The research method provides a new idea and reference for the efficiency evaluation of desulfurization and hydrogen production from coal liquefaction residue.

On the Electrolysis of Coal Slurries

A Novel Chemical-Electrochemical Hydrogen Production from Coal Slurry by a Two-Step Process: Oxidation of Coal by Ferric Ions and Electroreduction of Hydrogen Ions

Voltammetry and electrolysis of coal slurries and H-coal liquids

Characteristics and Anode Reaction of Organic Wastewater-Assisted Coal Electrolysis for Hydrogen Production

Hydrogen production from oxidation of coal slurries assisted by ferric ions

Study of producing hydrogen by electrolysis of coal slurries

Fe3+-mediated Coal-Assisted Water Electrolysis for Hydrogen Production: Roles of Mineral Matter and Oxygen-Containing Functional Groups in Coal

Effect of kinetic factors on hydrogen production by coal slurry electrolysis

Novel Pd–Co Electrocatalyst Supported on Carbon Fibers with Enhanced Electrocatalytic Activity for Coal Electrolysis To Produce Hydrogen

Experimental Study on Electrochemical Desulfurization of Coal Liquefaction Residue

Pre-combustion mercury removal with co-production of hydrogen via coal electrolysis

Mechanism Investigation Of Carboxyl Functional Groups Catalytic Oxidation In Coal Assisted Water Electrolysis Cell

Energy-saving and benign hydrogen production by coal gasification fine slag-assisted Water electrolysis

Roles of coal gasification wastewater in coal electrolysis for hydrogen production

Continuous hydrogen generation from lignite in supercritical water

Effect of acid concentration on organic structure and small molecule stripping of coal during acid treatment and electrolysis for hydrogen production

Two-step coal-assisted water electrolysis for energy-saving hydrogen production at cell voltage of 1.2 V with current densities larger than 150 mA/cm<SUP>2</SUP>

Hydrogen Production from Lignite Via Supercritical Water in Flow-Type Reactor

Oxidation mechanism for coal-assisted water electrolysis for hydrogen production: Evolution of different structures in coal molecules with reaction depth

Electrocatalytic oxidation of coal on Ti-supported metal oxides coupled with liquid catalysts for H2 production

Kinetics and oxidation pathways of Fe<SUP>3+</SUP>-catalyzed carbon-assisted water electrolysis for hydrogen production