Influence of isothermal aging in LDX 2101 duplex stainless steel on the microstructure and local properties

Naima Ouali,Billel Cheniti,Brahim Belkessa,Bouzid Maamache,Ramdhane Kouba,Maamar Hakem
DOI: https://doi.org/10.1007/s00170-021-07515-3
IF: 3.563
2021-07-05
The International Journal of Advanced Manufacturing Technology
Abstract:<p class="a-plus-plus">In the present work, the interface morphology and the evolution of nitride precipitates in LDX 2101 stainless steel isothermally treated at 750 °C for various aging times were investigated. The microstructure results showed that the Cr<sub class="a-plus-plus">2</sub>N nitrides precipitated along the <em class="a-plus-plus">δ</em>/<em class="a-plus-plus">γ</em> interface with 200 nm in length and continue to grow to 2 <em class="a-plus-plus">μ</em>m after 240 h of aging. However, only Cr<sub class="a-plus-plus">2</sub>N nitrides were found at the <em class="a-plus-plus">δ</em>/<em class="a-plus-plus">δ</em> interface after long term of aging. Atomic force microscopy (AFM) analysis revealed that Cr<sub class="a-plus-plus">2</sub>N nitrides and Cr<sub class="a-plus-plus">23</sub>C<sub class="a-plus-plus">6</sub> carbides started to precipitate after the first 10 min of aging with a small needle shape of the former and specific triangular morphology of the latter. The evolution of hardness and Young's modulus of the interfaces, performed with nano-indentation measurements, showed that the <em class="a-plus-plus">δ</em>/<em class="a-plus-plus">γ</em> interface became harder (4.1 ± 0.2 GPa) with increasing aging times, whereas negligible changes in the hardness and elastic modulus were recorded at the <em class="a-plus-plus">δ</em>/<em class="a-plus-plus">δ</em> interface. 3D topographic analysis of the immersed surfaces revealed that the susceptibility of <em class="a-plus-plus">δ</em> phase to preferential dissolution in 3.5% NaCl solution increased with aging time. This behavior was manifested by the important imperfections of <em class="a-plus-plus">δ</em> phase, the high surface roughness (55.7 nm), and the deep corrosion pits (30 nm) along the <em class="a-plus-plus">δ</em>/<em class="a-plus-plus">γ</em> interface and around the Cr<sub class="a-plus-plus">2</sub>N nitrides.</p>
What problem does this paper attempt to address?