Abstract:<span>The development of additive manufacturing and lattice structures has created opportunities for the development of lightweight impact–absorption structures that can overcome most constraints of previously used materials such as expanded polystyrene foams. However, for the successful application of such structures, the effects of their variables in their mechanical performance must be established. In this study, the mechanical properties and energy absorption of thermoplastic sheet gyroid structures were investigated and compared with the performance of current materials. Consequently, the specimens were tested after changing the main variables, i.e., cell size and volume fraction, of various thermoplastic materials such as acrylonitrile butadiene styrene, polylactic acid, thermoplastic polyurethane, and polyamide 12. Finally, they were tested in a quasi-static compression test and their deformation stages were photographed. The stress–strain curves of all materials changed after adopting the sheet gyroid structure, exhibiting three distinct regions: linear elastic, long collapse plateau, and densification that made them particularly applicable for energy absorption. Volume fraction affected the layer collapse. The elastic geometrical stiffness increased for higher volume fractions and smaller cells. In addition, the peak and plateau stresses increased at higher volume fractions, and while smaller cells were not directly affected. Additionally, the area under the curves increase with the volume fraction; hence, for most materials, specific energy absorption was larger for higher volume fractions. The constituent material properties contributed significantly to the structural behavior, exhibiting three primary deformation mechanisms, i.e., elastomeric, elastic–plastic, and elastic–brittle, resulting in a wide spectrum of properties for each application requirement. The comparison of the optimal properties with the expanded polystyrene demonstrated the ability of sheet gyroid structures to overcome most of its challenges, exhibiting a superior specific energy absorption, ability to withstand various impacts, letting air flow in its all axes, and being recyclable. Thus, sheet gyroid structures can be considered promising alternatives.</span>

Comparative analysis of mechanical properties and energy absorption capabilities of functionally graded and non-graded thermoplastic sheet gyroid structures

Mechanical properties and energy–absorption capabilities of thermoplastic sheet gyroid structures

Comparison of Mechanical Properties and Energy Absorption of Sheet-Based and Strut-Based Gyroid Cellular Structures with Graded Densities

Investigation of functionally graded TPMS structures fabricated by additive manufacturing

Compression and resilient behavior of graded triply periodic minimal surface structures with soft materials fabricated by fused filament fabrication

Comparative performance evaluation of microarchitected lattices processed via SLS, MJ, and DLP 3D printing methods: Experimental investigation and modelling

Evaluation of energy absorption capabilities and mechanical properties in FDM printed PLA TPMS structures

Effect of density and unit cell size grading on the stiffness and energy absorption of short fibre-reinforced functionally graded lattice structures

Mechanical behaviors of multidimensional gradient gyroid structures under static and dynamic loading: A numerical and experimental study

Mechanical Properties and Shape Memory Behavior of 4D Printed Functionally Graded Cellular Structures

Energy absorption behavior of stiffness optimized graded lattice structures fabricated by material extrusion

A review on functionally graded structures and materials for energy absorption

In-plane and out-of-plane compressive properties of regular and graded cellular cores of sandwich panels fabricated by additive manufacturing

Mechanical properties and deformation behavior of functionally graded TPMS structures under static and dynamic loading

Compressive behavior of selective laser melting printed Gyroid structures under dynamic loading

Rate-dependent energy dissipation of graded viscoelastic structures fabricated by grayscale vat photopolymerization

The Influence of the Structure Parameters on the Mechanical Properties of Cylindrically Mapped Gyroid TPMS Fabricated by Selective Laser Melting with 316L Stainless Steel Powder

Experimental and Computational Analysis of Energy Absorption Characteristics of Three Biomimetic Lattice Structures Under Compression

Impact response of additively manufactured density-graded open-cell foams

Energy absorption characteristics of functionally graded polymer-based lattice structures filled aluminum tubes under transverse impact loading

Numerical Modeling of Mechanical Behavior of Functionally Graded Polylactic Acid–Acrylonitrile Benzidine Styrene Produced via Fused Deposition Modeling: Experimental Observations