Abstract:Miniaturization of gas chromatography (GC) instrumentation is of interest because it addresses current and future issues relating to compactness, portability and field application. While incremental advancements continue to be reported in GC with columns fabricated in microchips (referred to in this paper as "microchip columns"), the current performance is far from acceptable. This lower performance compared to conventional GC is due to factors such as pooling of the stationary phase in corners of non-cylindrical channels, adsorption of sensitive compounds on incompletely deactivated surfaces, shorter column lengths and less than optimum interfacing to injector and detector. In this work, a GC system utilizing microchip columns was developed that solves the latter challenge, i.e., microchip interfacing to injector and detector. A microchip compression clamp was constructed to heat the microchip (i.e., primary heater), and seal the injector and detector fused silica interface tubing to the inlet and outlet ports of the microchip channels with minimum extra-column dead volume. This clamp allowed occasional operation up to 375°C and routine operation up to 300°C. The compression clamp was constructed of a low expansion alloy, Kovar™, to minimize leaking due to thermal expansion mismatch at the interface during repeated thermal cycling, and it was tested over several months for more than one hundred injections without forming leaks. A 5.9m long microcolumn with rectangular cross section of 158μm×80μm, which approximately matches a 100μm i.d. cylindrical fused silica column, was fabricated in a silicon wafer using deep reactive ion etching (DRIE) and high temperature fusion bonding; finally, the channel was coated statically with a 1% vinyl, 5% phenyl, 94% methylpolysiloxane stationary phase. High temperature separations of C10-C40 n-alkanes and a commercial diesel sample were demonstrated using the system under both temperature programmed GC (TPGC) and thermal gradient GC (TGGC) conditions. TGGC analysis of a complex essential oil sample was also demonstrated. Addition of a secondary heater and polyimide insulation proved to be helpful in achieving the desired elution temperature without having to raise the primary heater temperature above 300°C for high boiling point compounds.

Construction and Evaluation of a Low Cost Interface for the Determination of Elemental Speciation by Gas Chromatography Coupled to Inductively Coupled Plasma Mass Spectrometry (GC‐ICP‐MS)

Interfacing Nanoliter Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry with an In-Column High-Pressure Nebulizer for Mercury Speciation.

A demountable nanoflow nebulizer for sheathless interfacing nano-high performance liquid chromatography with inductively coupled plasma mass spectrometry

Coupling Electrophoretic Separation With Inductively Coupled Plasma Spectroscopic Detection: Interfaces And Applications From Elemental Speciation, Metal-Ligand Interaction To Indirect Determination

A Simple and Demountable Capillary Microflow Nebulizer with A Tapered Tip for Inductively Coupled Plasma Mass Spectrometry

Coupling nanoliter high-performance liquid chromatography to inductively coupled plasma mass spectrometry for arsenic speciation.

Simultaneous Measurements of Cr, Cd, Hg and Pb Species in Ng L-1 Levels by Interfacing High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry.

A Low-Cost Demountable Direct Injection High-Efficiency Nebulizer for Inductively Coupled Plasma Mass Spectrometry

Online anion exchange column preconcentration and high performance liquid chromatographic separation with inductively coupled plasma mass spectrometry detection for mercury speciation analysis.

Development and initial evaluation of a combustion-based sample introduction system for direct isotopic analysis of mercury in solid samples via multi-collector ICP-mass spectrometry

Simultaneous Quantification of Tin and Lead Species in Antarctic Krill and Fish by Interfacing High-Performance Liquid Chromatography with Inductively Coupled Plasma Mass Spectrometry Based on Strong Cation-Exchange and Amphion Columns

Improving Sensitivity for Microchip Electrophoresis Interfaced with Inductively Coupled Plasma Mass Spectrometry Using Parallel Multichannel Separation

A new HG/LT-GC/ICP-MS multi-element speciation technique for real samples in different matrices

Elimination of suction effect in interfacing microchip electrophoresis with inductively coupled plasma mass spectrometry using porous monolithic plugs.

Simultaneous Multi-Elemental Speciation of As, Hg and Pb by Inductively Coupled Plasma Mass Spectrometry Interfaced with High-Performance Liquid Chromatography

[Progress in Techniques of Interfacing Capillary Electrophoresis with Inductively Coupled Plasma Mass Spectrometry].

The online coupling of high performance liquid chromatography with atomic fluorescence spectrometry based on dielectric barrier discharge induced chemical vapor generation for the speciation of mercury

High Performance Liquid Chromatography Combined With Atomic Absorption Spectrometry Using Ultraviolet Digestion-Hydride Generation Interface

Extending the upper temperature range of gas chromatography with all-silicon microchip columns using a heater/clamp assembly

System Design for Integrated Comprehensive and Multidimensional Gas Chromatography with Mass Spectrometry and Olfactometry

Interfacing capillary electrophoresis with inductively coupled plasma mass spectrometry for redox speciation of plutonium