Abstract:The central diaphragm is often used to reduce the span to maintain the stability and safety of structure in the construction of large-span loess tunnel due to the structure complexities. In this paper, relying on the field monitoring and measurement for Wangcun tunnel in Huangling-Yan’an expressway expansion project, the crown settlement and horizontal convergence of primary support steel rib and central diaphragm steel rib during the construction are analyzed by the upper bench CD method. According to the internal force transfer, deformation coordination, and arch foot displacement between the two structures, the support system is regarded as the arch-beam fixed structure with three times of statically indeterminate and movable abutment under the loads, and the mechanical calculation model of sidewall steel rib and the central diaphragm structure bearing loads and deformation together is established. Finally, through the mechanical model mentioned above, the deformation characteristics of central diaphragm structure and the horizontal convergence in the upper bench of tunnel are calculated and analyzed. The research shows the following: (1) the accumulated settlement of sidewall steel rib in Part I is greater than that of the sidewall steel rib in Part II, and the accumulated settlement of each part at the support structure during the tunnel excavation is less than the reserved deformation of 150 mm specified in the tunnel excavation; (2) the settlement located at the waist and maximum excavation line position of central diaphragm is mainly affected by the excavation of Parts I and II in upper bench; (3) during the whole excavation process, the excavation of Part I and Part II has the greatest influence on the convergence at arch waist and the maximum excavation line position in Part I, and the convergence at the above two positions all experienced four stages of “convergence-expansion-convergence-gradual stability”; and (4) the errors between the horizontal convergence and the deformation of central diaphragm obtained by the mechanical model and the field monitoring data are between 12.7% and 27.5%. The calculated results are in good agreement with the actual situation. The research can provide a theoretical basis for the study of deformation and mechanical properties for support structure in the construction of large-span loess tunnel by the upper bench CD method.

Study on the Soil Structure and Construction Technology of Large Span Double-Arch Tunnel Entrance

Numerical Dynamic Simulation of the Construction Mechanics and Comparison and Choice of the Construction Method in the Bi-arch Tunnel of Express Highway

Design and application of a prefabricated structure for large-span arch open-cut highway tunnels

Stability analysis and optimization of excavation method of double-arch tunnel with an extra-large span based on numerical investigation

Structure Sesign and Optimization for Multi-Arch Tunnel with Big Arch Section

Study on Construction Mechanical Effect and Optimization of Large-Span Variable Cross-Section of Railway Tunnel

Study on Effect of Double-line Parallel Shield Tunneling Side-crossing on Adjacent Frame Structures

Study on the Stress and Deformation of Surrounding Rock and Support Structure of Super Large Section Tunnels Based on Different Excavation Methods

Study of Deformation Behaviors and Mechanical Properties of Central Diaphragm in a Large-Span Loess Tunnel by the Upper Bench CD Method

Damage and reliability analysis of double-arch tunnel without a middle pilot tunnel under blast load

Study on Bearing Mechanism and Coupling Mechanism of Steel Arch-concrete Composite Structure of Initial Support System of Large Section Tunnel

Mechanical responses of surrounding rock mass and tunnel linings in large-span triple-arch tunnel

A Case Study of Tunnel Reinforcement Measure during Traffic Upgrading in Chongqing City, China

The Effect of Section Width on Soil Arch in Utility Tunnel

Force Analysis of the Middle Wall in Multi-Arch Tunnel under Central Hole + CRD Method

Bearing effect of arched frame structures with longitudinal connections in large-section tunnels

Study on Identification of Construction Method for Ultra-Large-Span Tunnel

Large-scale geo-mechanical model tests for stability assessment of super-large cross-section tunnel

Construction techniques and mechanical behavior of newly-built large-span tunnel ultra-short distance up-crossing the existing shield tunnel with oblique angle

Force State Of Country Rock And Supporting Structure In Multi-Arch Tunnel Under Central Hole Plus Crd Method

Analysis of Arch Forming Factors of Shallow Buried Hard Rock Tunnel under Overlying Load