Abstract:Despite the intense research on photovoltaic lead halide perovskites, reported optical properties as basic as the absorption onset and the optical band gap vary significantly. To unambiguously answer the question whether the discrepancies are a result of differences between bulk and "near-surface" material, we perform two nonlinear spectroscopies with drastically different information depths on single crystals of the prototypical (CH3NH3)PbI3 methylammonium lead iodide. Two-photon absorption, detected via the resulting generation of carriers and photocurrents (2PI-PC), probes the interband transitions with an information depth in the millimeter range relevant for bulk (single-crystal) material. In contrast, the transient magneto-optical Kerr effect (trMOKE) measured in a reflection geometry determines the excitonic transition energies in the region near (hundreds of nm) the surface which also determine the optical properties in typical thin films. To identify differences between structural phases, we sweep the sample temperature across the orthorhombic-tetragonal phase transition temperature. In the application-relevant room-temperature tetragonal phase (at 170 K), we find a bulk band gap of 1.55 ± 0.01 eV, whereas in the near-surface region excitonic transitions occur at 1.59 ± 0.01 eV. The latter value is consistent with previous reflectance measurements by other groups and considerably higher than the bulk band gap. The small band gap of the bulk material explains the extended infrared absorption of crystalline perovskite solar cells, the low-energy bands which carry optically driven spin-polarized currents, and the narrow bandwidth of crystalline perovskite photodetectors making use of the spectral filtering at the surface.

Crystal‐Size‐Induced Band Gap Tuning in Perovskite Films

Crystalline Liquid-like Behavior: Surface-Induced Secondary Grain Growth of Photovoltaic Perovskite Thin Film

The balancing act between high electronic and low ionic transport influenced by perovskite grain boundaries

Quantum confinement effect on the electronic and optical properties of two-dimensional halide perovskites

Looking beyond the Surface: The Band Gap of Bulk Methylammonium Lead Iodide

Band-Gap Control via Structural and Chemical Tuning of Transition Metal Perovskite Chalcogenides

Thin Single Crystal Perovskite Solar Cells to Harvest Below-Bandgap Light Absorption

Size-Dependent Phase Transition in Perovskite Nanocrystals

Phonon-Driven Transient Bandgap Renormalization in Perovskite Single Crystals

Control over Crystal Size in Vapor Deposited Metal-Halide Perovskite Films

Pressure‐Induced Bandgap Optimization in Lead‐Based Perovskites with Prolonged Carrier Lifetime and Ambient Retainability

Tuning the optical bandgap in hybrid layered perovskites through variation of alkyl chain length

Suppressed phase separation of mixed-halide perovskites confined in endotaxial matrices

Band structure engineering in metal halide perovskite nanostructures for optoelectronic applications

Revealing unusual bandgap shifts with temperature and bandgap renormalization effect in phase-stabilized metal halide perovskite thin films

Regulating Crystal Orientation via Ligand Anchoring Enables Efficient Wide‐Bandgap Perovskite Solar Cells And Tandems

Optical Bandgap Anomaly with Tuning Dimensionality in Germanium Perovskites: Interplay Between Quantum Confinement and Lone Pair Expression

Revealing unusual bandgap shifts with temperature and bandgap renormalization effect in phase-stabilized metal halide perovskites

Revealing Unusual Bandgap Shifts with Temperature and Bandgap Renormalization Effect in Phase‐Stabilized Metal Halide Perovskite Thin Films

Nanoscale Bandgap Tuning across an Inhomogeneous Ferroelectric Interface

In situ nanoscopy of single-grain nanomorphology and ultrafast carrier dynamics in metal halide perovskites