A STUDY OF SILICONE OIL-IN-WATER EMULSIONS

BRAM A. SAADEVANDI,JACQUES L. ZAKIN
DOI: https://doi.org/10.1080/00986449708936678
1997-02-01
Chemical Engineering Communications
Abstract:Emulsions of silicone oil-in water were formed using a Brinkmann Polytron homogenizer with Igepal CO-530 as an emulsifier. Silicone viscosities ranged from 10 to 33,000 mPa.s at 25°C. Rheological characteristics and particle size analyses of silicone oil-in-water emulsions were studied. At high volume fraction of the dispersed phase (70%-75%), silicone oil-in-water emulsions were stable. At lower volume fractions (50%-60%), emulsions formed were less stable and the two phases easily separated in a few days. The emulsions formed with high volume fraction silicone oil show highly non-Newtonian behavior (shear thinning). Emulsions made with low viscosity oils had lower viscosities than those made from high viscosity oils. Relative viscosity-concentration data could be correlated by the Frankel and Acrivos Equation. Increasing the emulsifier concentration of 70% oil-in-water emulsions resulted in a decrease in mean droplet size and an increase in emulsion viscosity. Increasing the intensity of agitation also resulted in higher viscosity and smaller droplet size until a critical energy input above which droplet size increased. Emulsification with low shear mixing provides more control in decreasing mean droplet size with time.
What problem does this paper attempt to address?