Overview of Underwater Transmission Characteristics of Oceanic LiDAR

Guoqing Zhou,Chenyang Li,Dianjun Zhang,Dequan Liu,Xiang Zhou,Jie Zhan

DOI: https://doi.org/10.1109/jstars.2021.3100395

IF: 4.715

2021-01-01

IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing

Abstract:Oceanic LiDAR (hereafter referred to as O-LiDAR) is an important remote sensing device for measuring the near-coastal water depth and for studying the optical properties of water bodies. With the commercialization of LiDAR, the theoretical research on the underwater transmission characteristics of LiDAR has been intensified worldwide. Primary research interests include the simulation and modeling of LiDAR underwater echo signals and the inversion of optical parameters using LiDAR water echo signals. This article provides an overview of the principle of LiDAR echo signal formation, and comprehensively summarizes the LiDAR echo signal simulation modeling methods and the corresponding factors that affect modeling accuracy by focusing on the characteristics of different methods. We found that the current simulation methods of LiDAR underwater transmission echo signals primarily include an analytical method based on the radiation transfer equation and a statistical method based on the Monte Carlo (MC) model. The radiation transport equation needs to be appropriately simplified using the analytical method, usually using the quasi-single-small-angle approximation principle. The analytical method has high calculation efficiency but its accuracy is dependent to the quasi-single small-angle approximation. The statistical method can analyze the influence of various factors on echo signals by controlling the variables, but it has poor calculation efficiency. Finally, the semianalytical MC model was used to quantitatively analyze the three main factors (LiDAR system parameters, water body optical parameters, and environmental parameters) affecting underwater LiDAR transmission characteristics, and summarizes the mechanism and results of different factors.

imaging science & photographic technology,remote sensing,engineering, electrical & electronic,geography, physical

What problem does this paper attempt to address?

This paper aims to solve the problems regarding the underwater transmission characteristics of ocean lidar (O - LiDAR), especially to review the simulation and modeling methods of laser echo signals. Specifically, the paper focuses on the following aspects:

1. **Principle of Laser Echo Signal Formation**: The paper elaborates in detail on the entire process from the emission to the reception of the laser pulse when the O - LiDAR detects seawater, including phenomena such as the propagation, reflection, scattering, and absorption of the laser in the atmosphere and water.

2. **Simulation and Modeling Methods of Laser Echo Signals**: The paper summarizes the currently main laser echo signal simulation methods, including the analytical method based on the radiative transfer equation (RTE) and the statistical method based on the Monte Carlo model. Among them:
- **Analytical Method**: Usually, the quasi - single small - angle approximation is used to simplify the radiative transfer equation, which has high computational efficiency, but its accuracy depends on the approximate assumptions.
- **Statistical Method**: Analyze the influence of various factors on the echo signal by controlling variables, but it has low computational efficiency.

3. **Quantitative Analysis of Influencing Factors**: The paper uses the semi - analytical Monte Carlo model to quantitatively analyze the three main factors that affect the underwater lidar transmission characteristics: lidar system parameters, water body optical parameters, and environmental parameters, and summarizes the action mechanisms and results of different factors.

### Formula Display

1. **Expression of Water Body Echo Power**:
\[
P_c(t)=\frac{2}{\sqrt{\pi}}\int_{0}^{H}\left[\frac{(t - t_0)^2-\left(\frac{2(z - H)}{v}\right)^2}{4}\right]^{-\frac{3}{2}}\exp\left[-\frac{(t - t_0-\frac{2z}{v})^2}{4\left(\frac{2(z - H)}{v}\right)^2}\right]P(z)dz
\]
where:
- \(t\) is the two - way time delay.
- \(H\) is the working height of the lidar.
- \(t_0\) is the full width at half maximum of the Gaussian distribution.
- \(P(z)\) is the water body lidar equation.

2. **General Lidar Equation for Water Body Backscattering Elastic Scattering**:
\[
P(z)=\frac{2\pi\eta A_r}{(1 + s_l)\pi z^2}\exp\left[-2\int_{0}^{z}(\alpha(z')+\beta(z'))dz'\right]
\]
where:
- \(P\) is the average power of the initially emitted laser pulse.
- \(A_r\) is the receiving aperture area.
- \(\eta\) is the photoelectric conversion efficiency of the detector.
- \(s_l\) is the Fresnel reflection coefficient.
- \(\alpha(z)\) and \(\beta(z)\) are the effective attenuation coefficient and scattering coefficient of the water body respectively.

3. **Lidar Equation Based on Small - Angle Approximation**:
\[
I_{\text{rec}}(z,\Omega,r)=\frac{W_0}{4\pi V}\iiint b(z')\beta(\pi)I_{\text{src}}(z',\Omega',r)d\Omega'd\Omega''dz'
\]
where:
- \(W_0\) is the laser pulse energy.
- \(z\) is the detection depth.
- \(V\) is the propagation speed of the laser in water.
- \(r\) represents the projection of the scattering surface.