Abstract:This study addresses the formation control problem of multiple fixed-wing unmanned aerial vehicles (UAV) in three dimensions, taking into account assembly time and angle constraints. A novel control strategy is proposed, which divides the system into two modules. The first module, known as the assembly stage, assembles the UAV swarm and creates a fundamental formation from arbitrary initial states. Each UAV is required to reach the designated site while considering the terminal constraints regarding both time and angles. Novel sliding manifolds have been developed, and corresponding control laws are proposed to meet the constraints in the assembly stage. The Lyapunov stability theory is employed to prove that the proposed control laws guarantee a fixed-time stable system. The second module, referred to as the formation-keeping stage, is responsible for precisely maintaining the UAV swarm’s geometric pattern. The study proposes a sliding mode control (SMC) law that uses the traditional proportional navigation guidance (PNG) for followers to trace the relative trajectories of a predetermined central leader in a leader-follower structure. Finally, numerical simulation results are presented to demonstrate the successful implementation of the proposed approach. Compared to the two other methods, our proposed approach not only satisfies the constraints but also exhibits a higher level of distance accuracy. In precise terms, our method achieves a reduction in the average distance error of 73% and 87%, respectively, when compared to the previous two methods.

Robust fixed-time formation control for quadrotor unmanned aerial vehicles with directed topology

Formation Control of Multi-UAV Systems with Time and Angle Constraints

Finite-time Formation Tracking Control with Collision Avoidance for Quadrotor UAVs

Multi-UAV Formation Controller Design with Uncertain Dynamics

Adaptive Robust Time-Varying Formation Control of Quadrotors under Switching Topologies: Theory and Experiment

Fixed-time Integral-Type Sliding Mode Control for the Quadrotor UAV Attitude Stabilization under Actuator Failures

Robust Time-Varying Formation Control for a Set of Quad-Copters with Switching Interaction Communication Topology.

Distributed Fixed-Time Leader-Following Formation Control for Multiquadrotors with Prescribed Performance and Collision Avoidance.

Distributed Fixed-Time Time-Varying Formation-Containment Control for Networked Underactuated Quadrotor UAVs with Unknown Disturbances

Finite-time Distributed Event-Triggered Formation Control for Quadrotor UAVs with Experimentation

Adaptive Fuzzy Sliding Mode Fixed-Time Control for Quadrotor Unmanned Aerial Vehicles with Prescribed Performance

Observer based Appointed-finite-time Nonsingular Sliding Mode based Disturbance Attenuation Control for Quadrotor UAV*

Finite‐time Disturbance Observer‐based Trajectory Tracking Control for Quadrotor Unmanned Aerial Vehicle with Obstacle Avoidance

Fixed-time disturbance observer-based robust fault-tolerant tracking control for uncertain quadrotor UAV subject to input delay

Robust Cooperative Formation Control of Fixed-Wing Unmanned Aerial Vehicles

Robust Saturated Formation Tracking Control of Multiple Quadrotors with Switching Communication Topologies

Fully Distributed Time-Varying Formation Tracking Control for Multiple Quadrotor Vehicles Via Finite-Time Convergent Extended State Observer

Distributed fixed‐time sliding mode formation control for unmanned aerial‐ground vehicle (UAV‐UGV) heterogeneous system

Distributed robust adaptive formation control of fixed-wing UAVs with unknown uncertainties and disturbances

Robust Formation Control for Multiple Quadrotors Subject to Nonlinear Dynamics and Disturbances

Adaptive Formation Control of Quadrotor Unmanned Aerial Vehicles with Bounded Control Thrust