Abstract:The setting time of the paste and the rheological properties and microstructure of the mortar after replacing OPC cement with silica fume (SF), fly ash cenosphere (FAC) and nano-silica are studied as a reference for shotcrete applications. The suggested contents of SF, FAC and nano-silica are around 5–7.5%, higher than 20% and 1–3%, respectively, to meet the initial setting time specification. Viscosity and yield stress of mortar are highly dependent on water/cement ratio and paste/sand ratio. At the higher water/cement ratio, viscosity is more based on the paste itself. For SF of 2.5–10%, viscosity and yield stress increase, and the flowability of the mixture decreases. For FAC of 5–25%, viscosity and yield stress increase with a lower rate than SF, and flowability increases at 5% and then decreases as FAC content increases, which, however, is at the same level as the control. When SF and FAC are both added, a tortuous behavior of viscosity is shown. As nano-silica is further added, significant increases in viscosity and yield stress are shown. The compressive strengths of mortar with different supplementary cementitious materials (SCMs) at early ages are close. The difference in compressive strength after 28 days of standard curing is significant. The SF5-FAC15 group exhibits the largest increase in strength for 32.82%. At the age of 2.5 h, the macropore areas distribution of SF5-FAC25-NS1.5 test groups were 31.96%, indicating the lowest macropore area distribution. The secondary hydration reaction of supplementary cementitious materials (SCMs) continuously generates products that fill the pores, and the ultrafine filling effect of nanomaterials improves the compactness of the mortar microstructure and reduces the macropore area distribution. The mercury intrusion test results of the SF5-FAC25-NS1.5 group show that the pores are concentrated within the range of 0.01 to 0.05 μm, and the most probable pore size is significantly smaller than that of the CTR group. As the overall replacement level of SCMs increases, the diffraction peak of calcium hydroxide gradually weakens.

FTIR Analysis of Nanomodified Cement Concrete Incorporating Nano Silica and Waste Marble Dust

Use of AFM Technique to Study the Nano- Silica Effects in Concrete Mixture

INVESTIGATING THE EFFECT OF NANO SILICA ON THE MECHANICAL PROPERTIES OF HARDENED CEMENT PASTE

Influence of colloidal nanosilica on ultrafine cement hydration: Physicochemical and microstructural characterization

Nanoindentation Characteristics of Cement Paste and Interfacial Transition Zone in Mortar with Rice Husk Ash

Investigation of Accelerated Hydration in Nanosilica Incorporated Tricalcium Silicate using THz Spectroscopy

Determination of Hydrated Phases of Nanosilica incorporated C3S and \b{eta}-C2S using Nanoindentation Technique

Systematic investigation into mechanical strength, pore structure and microstructure of high performance concrete incorporating nano-hybrids

Microstructural Analysis of the Effect of Using Nano-silica on the Mechanical Properties of Cement–Sand Mortar Under the Effect of Heat

Synergistic effect of nano silica and metakaolin on mechanical and microstructural properties of concrete: An approach of response surface methodology

Hydration and Mechanical Properties of High-Volume Fly Ash Concrete with Nano-Silica and Silica Fume

Influence of silicon-dioxide nanoparticles in cementitious mortars: verification using X-ray diffraction, thermal analysis, physical, and mechanical tests

Rheological behaviour, setting time, compressive strength and microstructure of mortar incorporating supplementary cementitious materials and nano-silica

Experimental Investigation and Image Processing to Predict the Properties of Concrete with the Addition of Nano Silica and Rice Husk Ash

A Raman Spectroscopic Study of Calcium Silicate Hydrate (CSH) in the Cement Matrix with CNTs and Oxide Additives

Evaluating the impact of nano-silica on characteristics of self-compacting geopolymer concrete with waste tire steel fiber

Mix and measure II: joint high-energy laboratory powder diffraction and microtomography for cement hydration studies

Evaluation of the nanostructure of calcium silicate hydrate based on atomic force microscopy-infrared spectroscopy experiments

Study on the reinforcing mechanisms of nano silica to cement-based materials with theoretical calculation and experimental evidence

A Review of the Effect of Nano-Silica on the Mechanical and Durability Properties of Cementitious Composites

Effect of silica fume on fracture analysis, durability performance and embodied carbon of fiber-reinforced self-healed concrete