Abstract:Lithium-ion battery (LIB) electrolytes are generally composed of an organic hydrocarbon and lithium salt (e.g., LiPF 6 ). The effect of salt addition to the electrolyte solvent increases its density. Experimental density data for basic and realistic, multicomponent mixtures are scarce in the literature, and a predictive model for electrolyte solution density is not yet available. This work resolves to create a predictive method that can be used to estimate the density of these mixtures. A predictive method which accounts for intramolecular forces in the electrolyte mixture was developed and fit to the sparse density data available in the literature. The model exhibited high accuracy for single component electrolyte mixtures with most predictions falling within 1% of measured values and all predictions falling within 5%. The model was further extended to more realistic, multi-solvent electrolyte mixtures which exhibited similar accuracy, seen in Fig. 1. It was noted that the multi-component predictions were moderately worse than for the single component mixtures. The source of this disparity is not clear but may be derived from uncertainty in the data reported by electrolyte vendors and/or the presence of solvent-to-solvent interactions in the solution which are not accounted for in the current modeling framework. In addition to the density model, an accurate method for computing absolute molar and mass fractions of multi-solvent mixtures with specified volumetric concentrations (e.g., 1.2 M LiPF 6 in 1:1:1 %vol. EC/ DEC/DMC) is also described for when that is the only known relation for a solution. Computed mass concentration values yielded an average error of 1.4% with a maximum value of 9.6%. The molar and mass approaches were combined to yield a modeling framework capable of computing molar concentrations and densities of all LIB electrolyte solutions based on LiPF 6 loaded in any combination of ethylene carbonate (EC), ethyl methyl carbonate (EMC), diethyl carbonate (DEC), dimethyl carbonate (DMC), and propylene carbonate (PC). The largest fault with the final modeling system is that it suffers from a lack of sufficient, high-quality experimental data for validation of its accuracy over a wide range of electrolyte formulations and conditions. This model’s accuracy is dependent on the experimental data utilized for correlation. Accordingly, more data from differing sources will help increase the accuracy and confidence of the model developed herein and allow it for expansive use in LIB fields. Future work will be required to extend the current approach to any novel electrolyte formulations developed in the research and development sector. Figure 1

A Density Model for Multicomponent Liquids Based on the Modified Quasichemical Model: Application to the NaCl-KCl-MgCl2-CaCl2 System

Thermodynamics of brine-salt equilibria—I. The systems NaCl-KCl-MgCl2-CaCl2-H2O and NaCl-MgSO4-H2O at 25°C

Molecular interaction volume model of mixing enthalpy for molten salt system: An integrated calorimetry-model case study of LaCl$_3$-(LiCl-KCl)

Thermodynamic modeling of the LiCl-KCl-LaCl$_3$ system with Bayesian model selection and uncertainty quantification

Thermodynamic modeling and phase diagram prediction of salt lake brine systems. I. Aqueous Mg2+–Ca2+–Cl− binary and ternary systems

Comparison of Different Calculation Methods of the New Generation Geometric Model in Predicting the Density of NaCl–MgCl2–CaCl2 Systems

Thermodynamic Model of the H2O–LiCl–NaCl System for Study of Fluid Inclusions: Calculations Using the Pitzer Equations

Atomistic Simulation Framework for Molten Salt Vapor-Liquid Equilibrium Prediction and its Application to NaCl

On the analogy between the restricted primitive model and capacitor circuits. Part II: A generalized Gibbs-Duhem consistent extension of the Pitzer-Debye-Hückel term with corrections for low and variable relative permittivity

A critical review of models for density, viscosity, and diffusivity in aqueous sodium chloride solutions

Experiment and Modeling of Vapor–liquid Equilibria for H2O+CH3OH+KCl and H2O+CH3OH+NaBr Systems

A unified surface tension model for multi-component salt, organic, and surfactant solutions

Molecular simulation of thermodynamic and transport properties for the H2O+NaCl system

A Set of Molecular Models for Alkaline-Earth Cations in Aqueous Solution

A Model for Lithium-Ion Battery Electrolyte Mixture Densities

Sodium Chloride, NaCl/ε : New Force Field

Liquid-Vapor Phase Equilibrium in Molten Aluminum Chloride (AlCl3) Enabled by Machine Learning Interatomic Potentials

Density anomaly of charged hard spheres of different diameters in a mixture with core-softened model solvent. Monte Carlo simulation results

A tentative model for estimating the compressibility of rock-salt AgCl_{x}Br_{1-x} alloys

Ab initio molecular dynamics assessment of thermodynamic and transport properties in (K,Li)Cl and (K, Na)Cl molten salt mixtures

Quantum Chemistry-Based Approach for Density Prediction of non-ionic Hydrophobic Eutectic Solvents