Removal and recovery of uranium (VI) from aqueous solution by adsorption of surface aldehyde assembled polystyrene microspheres

Jingbo Ni,Ruyi Liu,Changhao Yan

DOI: https://doi.org/10.5004/dwt.2021.27217

IF: 1.1

2021-01-01

Desalination and Water Treatment

Abstract:The surface aldehyde assembled polystyrene microspheres (PS-CHO) were synthesized via the copolymerization of styrene and acrolein and characterized by Fourier-transform infrared spectroscopy and transmission electron microscopy. Some characteristic parameters, such as specific surface area, pore diameter distribution and zeta potential, were also determined. The content of aldehyde groups in the PS-CHO microspheres was inferred through potentiometric titration. Adsorption of uranium(VI) from an aqueous solution was investigated in a series of variable experiments. Effect of pH value, ionic strength, adsorbent dose, contact time and temperature on uranium(VI) adsorption were also discussed. Results showed that the optimum condition was the temperature of 313 K, 0.4 g L–1 of adsorbent dosage, pH value of 6.0 for 20 mg L–1 of uranium(VI) concentration. The maximum removal efficiency of uranium(VI) ions was 92.13%. Kinetic studies certified the pseudo-second-order was the best-suited model and the fitting linear plot of the intraparticle diffusion model did not pass the origin, indicating that chemical sorption was the rate-determining step of the adsorption mechanism rather than mass transfer. Also, the Elovich equation was consistent with the experimental data, meaning chemical interactions between microspheres and adsorbates. The adsorption capacity at the equilibrium of PS-CHO microspheres was estimated to be 46.07 mg g–1 at 313 K. Furthermore, about 96% of adsorbed uranium(VI) could be recovered by laconic perchloric acid treatment, suggesting the stability and reusability of PS-CHO microspheres.

engineering, chemical,water resources