Abstract:Polymeric felts are commonly used in the papermaking process on the paper machine wet end, in the press section, and in the dryer section. They provide an important function during paper manufacturing, including as a carrier or support; as a filter media assisting with water removal on the paper machine; in retention of fibers, fines, and fillers; and in some applications, such as tissue and towel, to impart key structural features to the web. These felts can have highly interwoven complex internal structures comprised of machine direction and cross-machine direction yarns of varying sizes and chemical compositions. Here, we present a non-intrusive three-dimensional (3D) image visualization method using advanced X-ray computed tomography (XRCT). This method was used to characterize the complex 3D felt structure and determine the water removal characteristics of some commonly used paper machine felts. The structural features analyzed include porosity; specific pore-yarn interfacial surface area; 3D pore size distribution; 3D fiber or yarn-size distribution; and their variations through the thickness direction. The top, middle, and bottom layers of the felt have very different structures to assist with water removal and impart paper properties. The size distribution of the yarns, as well as the pores in the different layers of the felt, are also inherently different. These structural features were non-intrusively quantified. In addition, variation in the structural characteristics through the thickness of the felts and its potential role in papermaking is explored. In addition to the 3D structural characteristics, permeability characteristics and water removal characteristics, including rewetting of select felt samples, have also been experimentally determined. It is interesting to observe the relationship between key structural features and permeability and water removal characteristics. These relationships can provide additional insights into press felt design, as well as ways to improve product properties and the dewatering efficiency and productivity of the paper machine.

Three-dimensional visualization and characterization of paper machine felts and their relationship to their properties and dewatering performance

Chemical Treatment of Carbon Fibers and the Development of Functional Paper

Interfacial Modiﬁcation and Dispersion of Short Carbon Fiber and the Properties of Composite Papers As Gas Diffusion Layer for Proton Exchange Membrane Fuel Cell (PEMFC)

Multidirectional permeability simulation for fiber network based on the pore structure 3D characterization by CT scanning

Full-field, quasi-3D hygroscopic characterization of paper inter-fiber bonds

Experimental Research on Thermo-Direct Fiber Drawing Technique

The role of fibre bonds in permanent curl of paper and how it is affected by crosslinking

3D Metapaper with Unprecedented Mechanical Properties under Water

New advances in the 3D characterization of mineral coating layers on paper.

Near Pixel-Level Characterisation of Microfibres in 3D-Printed Cementitious Composites and Migration Mechanisms Using a Novel Iterative Method

Enhancing subsequent kraft fiber dewatering properties by using fiber polyamide-epichlorohydrin (PAE) treatment to prepare a dry pulp product,

Eucalyptus Pulp Fibers with In-Situ Precipitated Calcium Carbonate – A 12-Inch Laboratory Paper Machine Study

Three-dimensional spiral model of the wicking effect for continuous polyester filaments

Analyses of the effects of fiber diameter, fiber fibrillation, and fines content on the pore structure and capillary flow using laboratory sheets of regenerated fibers

AFM-based low frequency viscoelastic characterization of wood pulp fibers at different relative humidity

Semi-theoretical compression model of wet fiber web for the prediction of airflow rate in vacuum dewatering process of papermaking

A Study of Structure–Property Correlation on Wet Spinning Conditions in Heat-Resistant Poly(m-phenylene isophthalamide) Hollow Fiber Membranes

Rate-limiting mechanisms of water removal during the formation, vacuum dewatering, and wet-pressing of paper webs: A review

The Wicking Performance of Interlaced Silk Yarn Focusing on Yarn Parameters

Electric Field Simulation and Effect of Different Solvent Ratios on the Performance of Single Electrospun PVDF/PEI Composite Film

Effect of polydispersity on the transport and sound absorbing properties of three-dimensional random fibrous structures