Abstract:Continuous dynamic recrystallization (CDRX) is widely acknowledged to occur during hot forming and plays a significant role in microstructure development in alloys with moderate to high stacking fault energy. In this work, the flow stress and CDRX behaviors of the TC18 alloy subjected to hot deformation across a wide range of processing conditions are studied. It is observed that deformation leads to the formation of new low-angle grain boundaries (LAGBs). Subgrains rotate by absorbing dislocations, resulting in an increase in LAGB misorientation and the transition of some LAGBs into high-angle grain boundaries (HAGBs). The HAGBs migrate within the material, assimilating the (sub)grain boundaries. Subsequently, an internal state variable (ISV)-based CDRX model is developed, incorporating parameters such as the dislocation density, adiabatic temperature rise, subgrain rotation, LAGB area, HAGB area, and LAGB misorientation angle distribution. The values of the correlation coefficient (R), relative average absolute error (RAAE), and root-mean-square error (RMSE) between the anticipated true stress and measured stress are 0.989, 6.69%, and 4.78 MPa, respectively. The predicted outcomes demonstrate good agreement with experimental findings. The evolving trends of the subgrain boundary area under various conditions are quantitatively analyzed by assessing the changes in dynamic recovery (DRV)-eliminated dislocations and misorientation angles. Moreover, the ISV-based model accurately predicts the decreases in grain and crystallite sizes with higher strain rates and lower temperatures. The projected outcomes also indicate a transition from a stable and coarse-grained microstructure to a continuously recrystallized substructure.

In Situ Observations and Microstructure Evolution Behavior of Static Recrystallization of Microalloyed Continuous Casting Slabs in a Solidification End Reduction Process

In-situ Study of Microstructure and Mechanical Properties of GH3536 Alloy Manufactured by Selective Laser Melting at 750 °C

Microstructure and Microtexture Evolution Characteristics of a Powder Metallurgy Ni-based Superalloy During Static Recrystallization

In situ observation and investigation of effect of cooling rate on slab surface microstructure evolution in microalloyed steel

Microstructure Simulation on Recrystallization of an As-Cast Nickel Based Single Crystal Superalloy

Investigation of Isothermal Continuous Hot Deformation Behavior of the New As-Cast Alumina-Forming Austenitic Alloy

Interaction of Strain Refined Precipitates and Recrystallized Grains in Nb-Ti Microalloyed Steel during Continuous Casting, Hot-Core Heavy Reduction Rolling, and Reheating Process

Microstructure and Texture Optimization by Static Recrystallization Originating from {10-12} Extension Twins in a Mg-Gd-Y Alloy

An improved cellular automaton model of dynamic recrystallization and the constitutive model coupled with dynamic recrystallization kinetics for microalloyed high strength steels

Experimental Investigations and Constitutive Modeling of the Dynamic Recrystallization Behavior of a Novel GH4720Li Superalloys with Yttrium Micro-Alloying

Modeling of Microstructural Evolution During Dynamic Recrystallization in Coarse Nb Microalloyed Austenite

In situ study the effect of refiner on the microstructure evolution of variable cross-section structure by synchrotron X-ray radiography

An Analysis of Dynamic Recrystallization During the Reduction Pretreatment Process Using a Multiscale Model

An Internal-State-Variable-Based Continuous Dynamic Recrystallization Model for Thermally Deformed TC18 Alloy

Influence of hot-core heavy reduction rolling on microstructure uniformity of casting billet

A 3D Cellular Automaton with Inhomogeneous Nucleation for Simulating Dynamic Recrystallization of Low-Alloy Steel with Mixed-Grain Microstructure

Microstructure and Microtexture Evolution of Dynamic Recrystallization of a Ni-based Superalloy under High-Throughput Gradient Thermal Compression

Study of static recrystallization behavior in hot deformed Ni-based superalloy using cellular automaton model

Investigation on Sub-Solvus Recrystallization Mechanisms in an Advanced γ-γ’ Nickel-Based Superalloy GH4151

The In-Situ Study on the Micro-Structural Characters of if Steel at Early Stage of Recrystallization Using High-Energy X-Ray

Microstructural and micromechanical evolution during dynamic recrystallization