Abstract:There is an increasing need for lightweight structures in the transportation industry, and within these lightweight structures occupant safety is continually important to all stakeholders. Standard single and multi-material topology optimization (MMTO) techniques are effective for designing lightweight structures subjected to linear objectives and constraints but cannot consider crashworthiness. Crashworthiness must be evaluated using explicit dynamic simulation techniques, as a crash event contains geometric and material nonlinearities which cannot be captured by linear static finite element simulations. Explicit dynamic simulations prevent the calculation of sensitivity derivatives required for conventional gradient-based structural optimization strategies. This paper describes a design tool for multi-material topology optimization considering crashworthiness using the equivalent static load (ESL) method. The ESL method is used to generate linear static sub-problems which replicate the dynamic structural response of explicit dynamic crash simulations in the linear regime. The ESL sub-problems are input to a standard MMTO, optimized results from which are used as input for subsequent crash analyses to update the ESLs for additional sub-problems. The ESLs evolve as the design changes – convergence occurs when the design does not change significantly between subsequent sub-problem optimizations. The objective of this paper is to demonstrate a methodology for an efficient design tool for MMTO considering crashworthiness. Firstly, the ESL and competing methods for crashworthiness optimization are introduced and compared. Next a discussion of the tool’s operation flow as well as the sensitivity equations are presented along with two academic examples demonstrating its implementation. The design tool generates optimized multi-material designs which outperform single-material optimized designs in terms of mass by 7.5% and 17.6% in 2D and 3D models respectively when subjected to crash load cases.

Topology optimization for fail-safe designs using moving morphable components as a representation of damage

Topology optimization of damage‐resistant structures with a predefined load‐bearing capacity

Adaptive topology optimization of fail-safe truss structures

Robust topology optimization of continuum structures with smooth boundaries using moving morphable components

The Path-Engulfment Method for Topology Optimization of Structures

A stochastic framework for computationally efficient fail-safe topology optimization

A new topology optimization approach based on Moving Morphable Components (MMC) and the ersatz material model

Topology optimization for minimum stress design with embedded movable holes

Topology optimization for transient response of structures subjected to dynamic loads

Multi-Material Topology Optimization Considering Crashworthiness

Stabilized Time-Series Moving Morphable Components Method for Topology Optimization

Self-consistent Clustering Analysis-Based Moving Morphable Component (SMMC) Method for Multiscale Topology Optimization

Moving morphable component (MMC) topology optimization with different void structure scaling factors

Optimal Structures for Failure Resistance Under Impact

Topology optimization for enhanced dynamic fracture resistance of structures

Topology optimization of thin-walled cross section using moving morphable components approach

Efficient topology optimization for geometrically nonlinear multi-material systems under design-dependent pressure loading

Moving Morphable Curved Components Framework of Topology Optimization Based on the Concept of Time Series

Topology optimization with continuously varying load magnitude and direction for compliance minimization

Moving Morphable Components Using Strain-Based Beam Geometry Description for Topology Optimization

Topology optimization of degradable composite structures with time‐changeable stiffness