Performance of Compost and Hog-Fuel Biofilters: Impact of Periods of Non-Use and Varying Methyl Mercaptan Loading

A. H. Wani,A. K. Lau,R. M. R. Branion

DOI: https://doi.org/10.1080/09593332108618116

IF: 3.475

2000-03-01

Environmental Technology

Abstract:The work reported here describes the aerobic biodegradation in biofilters of methyl mercaptan, which is a foul smelling compound found in the air emissions from Kraft pulp mills. Experiments were conducted in three bench-scale biofilters packed with the mixtures of compost/perlite (4:1), hog fuel/perlite (4:1), and compost/hog fuel/perlite (2:2:1), respectively. These biofilters were exposed to variations in methyl mercaptan concentration, fluctuating waste airflow rate, and periods of non-use to evaluate the effects of changes in contaminant mass loading and starvation on biofilter dynamics and performance. Inoculation of the biofilter materials with pulp mill wastewater sludge significantly reduced the initial start-up time. The initial acclimation period for the three biofilters was about 56 hours. During that time the outlet methyl mercaptan concentration declined from 2 to 1 ppmv and the elimination capacities remained constant at around 6 g m−3 h−1. Step changes in methyl mercaptan concentration and waste airflow rate demonstrated that the biofilters acclimatized rapidly to the new operating conditions. However, an inlet concentration of about 109 ppmv caused a measurable decrease in the % removal and elimination capacity of the biofilters, so did a waste airflow rate of 2.9 m3 h−1. A massive reduction in % removal and elimination capacity of all the three biofilters was observed when the inlet mercaptan concentration rose to 141 ppmv, moreover the biofilters could not recover to the % removal and elimination capacity levels they had before this increase. In most cases about 8 - 16 h were needed, after the step changes, by the biofilters to recover to initial removal capacity. All three biofilters exhibited diminished levels of performance immediately after the inlet mercaptan concentration was raised from 88 ppmv to 158 ppmv and held there for 30 minutes. After that the inlet concentration returned to 88 ppmv and the biofilters' original levels of performance were regained in 1 - 6 hours. The re-acclimation time was dependent on the duration of the non-use period, and was much shorter following a no-contaminant-loading phase than that after an idle phase. The re-acclimation time (≈ 1 day) for the biological activity after the longest starvation period of one-week was much shorter than the initial start-up time of 5 – 6 days.

environmental sciences