Abstract:Nowadays, high-frequency switching power amplifiers (SPA) have been studied widely; bulk of the researches were focused on audio power amplifiers. In active magnetic bearing (AMB) systems, high-frequency electromagnetic excitation caused by rotor imbalance can affect the performance of the SPA, so the traditional SPA cannot meet the requirements of the AMB systems. Therefore, on the premise of ensuring larger power, the frequency of the SPA should be improved to ensure the normal operation of the AMB system. Two-level pulsewidth modulation (PWM) current-mode SPAs are widely used in AMB systems. In order to broaden the bandwidth and to reduce the average steady-state error current, SiC power devices based SPA with a high bus voltage and a high switching frequency was designed. The basic principle and the linearized control model of SPAs are introduced. Then, the duty ratio stability and average steady-state error current of the SPAs are analyzed based on the output ripple current. When the PWM modulator is designed by either the discrete devices or the integrated chips, the critical gains to ensure the duty ratio stability are, respectively, analyzed based on the slope matching and the nonideal characteristic of operational amplifiers. Hence, two methods to reduce the average steady-state error current are proposed, respectively. One is to adjust the offset voltage of triangular carrier for the P controller, the other is to use a proportional integral (PI) controller. The offset adjusting method allows the SPA to achieve better dynamic performance and wider bandwidth. The proportional integral (PI) controller can reduce the average steady-state error current but narrows the bandwidth. Finally, the experiment results are in good agreement with the theoretical analyses.

Error analysis on single sideband modulator

Comparison Of Dsb And Ssb Demodulation Methods In General Control System Of Mems Gyroscopes

A Silicon Optical Single Sideband Modulator with Ultra-High Sideband Suppression Ratio

Single Chip Silicon Single Sideband Modulator with High Sideband Suppression Ratio

Modeling of a 200 KHz Bandwidth Low-pass Switch-capacitor Sigma-delta DAC with a Raised Spur-free Modulator

High Sideband Suppression Silicon Single Sideband Modulator Integrated with a Radio Frequency Branch Line Coupler

Duty Ratio Stability and Average Steady-State Error of Two-Level Current-Mode Wide-Bandwidth Switching Power Amplifiers

Spectrum Analysis of Phase Amplitude Modulation

Influence Of Loss On Linearity Of Microring-Assisted Mach-Zehnder Modulator

Analysis and Signal Recovery of Modulated Wideband Converter with Gain Mismatch

The Analysis on Improving Linearity of Microring-Assisted Mach-Zehnder Modulator

Impact of Nonlinear Transfer Function and Imperfect Splitting Ratio of MZM on Optical Up-Conversion Employing Double Sideband with Carrier Suppression Modulation

Design and research on low power system for ∑△ Modulator

The Correction of Phase Error for MA-SOQPSK Modulation

Performance Analysis of Nonlinear Spatial Modulation Multiple-Input Multiple-Output Systems

Key Issues for Low Voltage Σ-Δ Modulator and Design Example

AM-to-PM bit error rate analysis for QPSK signals

A Novel Analog Linearizer for Solid-State Power Amplifier in Satellite Communication System

A 20 Mw 12-Bit Continuous-Time Σ-Δ Modulator with 5 MHz Signal Bandwidth

Behavioral Model of Sigma Delta Modulator by Introducing Phase Margin

An Improved Single-Loop Sigma-Delta Modulator for GSM Applications