Modification of asphalt binder by the blend of chemically grafted thermoplastics and SBS: Influence of blend composition, chemical grafting, sulphur content, and MFI value

Akanksha Pandey,Alok Sharma,Sham S. Ravindranath

DOI: https://doi.org/10.1007/s00289-021-03868-7

IF: 2.843

2021-09-04

Polymer Bulletin

Abstract:Thermoplastic elastomers, such as styrene–butadiene–styrene (SBS), significantly enhance the properties of asphalt binders. This study first highlights the drawbacks of binder modification using chemically grafted polyethylene (g-PE) and then demonstrates the process by which g-PE can be used in combination with SBS. The important role of chemical grafting, sulphur content, and melt flow index (MFI) value in obtaining practically usable 'g-PE/SBS' modified binders have been illustrated. The results show that ungrafted and g-PE produces modified binders with highly inferior properties, and the polymers phase separate from the binder within few hours of preparation. % Elastic recovery of the ungrafted and g-PE modified binders was < 30%, and the softening point was 10 to 25 °C lower than SBS modified binders. Modification using the '50/50' g-PE/SBS blend also resulted in inferior modified binders. On the other hand, the '25/75' g-PE/SBS blend resulted in modified binders with properties similar to SBS modified binders. Chemical grafting, sulphur content of 0.21 wt.%, and melt flow index value > 2 are the essential factors that resulted in acceptable '25/75' g-PE/SBS modified binders. Cost analysis shows that the use of g-PE can reduce the overall cost of asphalt pavement. The strategy illustrated in this study can be adopted for low-cost polymers and the effective utilization of waste plastics.

polymer science