Abstract:This paper analyzes a recently introduced two-motor five-phase drive system with series connection of stator windings. It has been shown, using physical reasoning, that the introduction of an appropriate phase transposition in the series connection of two machines leads to a complete decoupling of the flux/torque-producing currents of one machine from the flux/torque-producing currents of the second machine. Consequently, independent vector control of the two machines becomes possible while using a single current-controlled five-phase voltage source inverter as the supply. The drive system modeling and control are first elaborated in this paper by taking both machines as induction motors. It is shown, using rigorous mathematical derivations, that the independent control of the two machines results due to the placement of machines in two different subspaces of the five-dimensional space. This is enabled by phase transposition in series connection. The models of the complete drive in the stationary common reference frame and in the rotor-flux-oriented reference frames of the two machines are developed. An associated vector control scheme for the two-motor drive is presented next. The second part of this paper describes an experimental setup used further on to evaluate the dynamic behavior of the two-motor drive. Performance is investigated by extensive experimentation for various transients (acceleration, deceleration, reversing, and disturbance rejection). Excellent decoupling of control of the two machines is achieved. Both the concept of the drive and the approach to modeling and control are thus fully verified experimentally. Finally, the advantages and shortcomings of the series-connected five-phase two-motor drive are discussed, and potential application areas are highlighted.

Exploitation of the Power Capability in a Five-Phase Doubly Fed Induction Motor Drive for Contact-Less Energy Transfer

Dual Closed-Loop Control Strategy on Harmonic Plane for Multiphase Induction Motor with Harmonic Injection Based on Air-Gap Flux Orientation Control

A Multipulse Pattern Modulation Scheme for Harmonic Mitigation in Three-Phase Multimotor Drives

Principle And Realization Of A 5-Phase Pm Bearingless Motor Drive

Sensorless Control for Five-phase Induction Motors With Improved Third-harmonic Current Injection

Modeling, Control, and Experimental Investigation of a Five-Phase Series-Connected Two-Motor Drive With Single Inverter Supply

Electronic pole-changing methods of five-phase induction machine based on torque tracking

Analysis and Experiment of a 6-Phase Bearingless Induction Motor

Air-gap and Yoke Flux Density Optimization for Multiphase Induction Motor Based on Novel Harmonic Current Injection Method

Electronic pole-changing methods of multiphase induction motors based on exponent response

Analysis of a New 5-Phase Bearingless Induction Motor

Analysis and Design of an Electric Machine Employing a Special Stator With Phase Winding Modules and PMs and a Reluctance Rotor

A Novel Bidirectional Wireless Power Transmission System for Doubly-fed Motor

Induction motor control via the rotor of a doubly fed induction generator

Variable-Speed Five-Phase Induction Motor Drive Based on Predictive Torque Control

Direct Torque Model Predictive Control of a Five-Phase Permanent Magnet Synchronous Motor

Simple Strategy To Recovery Energy During Stopping Period In Large High-Inertia Line-Fed Induction Motor Driven Systems

Single-Phase to Three-Phase Electrolytic Capacitor-Less Dual Inverter-Fed IPMSM for Suppress Torque Pulsation

Design of Complex Vector Controller for High-power Induction Machine Drive

An Enhanced Fault-Tolerant Control of a Five-Phase Synchronous Reluctance Motor Fed from a Three-to-Five-phase Matrix Converter

Optimization Of The Five Phase Fault Tolerant Motor Based On Ansoft Simulation