Abstract:Although the elastic properties of porous materials depend mainly on the volume fraction of pores, the details of pore distribution within the material representative volume are also important and may be the subject of optimisation. To study their effect, experimental analyses were performed on samples made of a polymer material with a predefined distribution of spherical voids, but with various porosities due to different pore sizes. Three types of pore distribution with cubic symmetry were considered and the results of experimental analyses were confronted with mean-field estimates and numerical calculations. The mean-field 'cluster' model is used in which the mutual interactions between each of the two pores in the predefined volume are considered. As a result, the geometry of pore distribution is reflected in the anisotropic effective properties. The samples were produced using a 3D printing technique and tested in the regime of small strain to assess the elastic stiffness. The digital image correlation method was used to measure material response under compression. As a reference, the solid samples were also 3D printed and tested to evaluate the polymer matrix stiffness. The anisotropy of the elastic response of porous samples related to the arrangement of voids was assessed. Young's moduli measured for the additively manufactured samples complied satisfactorily with modelling predictions for low and moderate pore sizes, while only qualitatively for larger porosities. Thus, the low-cost additive manufacturing techniques may be considered rather as preliminary tools to prototype porous materials and test mean-field approaches, while for the quantitative and detailed model validation, more accurate additive printing techniques should be considered. Research paves the way for using these computationally efficient models in optimising the microstructure of heterogeneous materials and composites.

Optimization of 3D printed porous materials accounting for manufacturing defects

Efficient Biscale Design of Semiregular Porous Structures with Desired Deformation Behavior

PERFORMANCE ORIENTED DESIGN OF SEMIREGULAR ANISOTROPIC POROUS STRUCTURES

Efficient modelling of surface roughness effects in additively manufactured materials

Design and Additive Manufacturing of Porous Sound Absorbers-A Machine-Learning Approach

Cubic elasticity of porous materials produced by additive manufacturing: experimental analyses, numerical and mean-field modelling

3D printed sound-absorbing materials with double porosity

Designing hybrid aerogel-3D printed absorbers for simultaneous low frequency and broadband noise control

Acoustic modelling of 3D-printed hybrid materials: a preliminary study

Noise Pollution Reduction Through a Novel Optimization Procedure in Passive Control Methods

Effect of Porosity on Mechanical Properties of 3D Printed Polymers: Experiments and Micromechanical Modeling Based on X-Ray Computed Tomography Analysis

3-D printed membrane-type acoustic metamaterials with tailored performance

Enhancement of the sound absorption of closed-cell mineral foams by perforations: Manufacturing process and model-supported adaptation

Infill Optimization for Additive Manufacturing -- Approaching Bone-like Porous Structures

3D Printed Nature Pattern Metastructure for The Sound Absorption Coefficient

Bottom-up approach for microstructure optimization of sound absorbing materials

An adaptive matrix material extrusion optimization model for in situ impregnated continuous fiber-reinforced 3D printing

Incorporation of Defects in Finite Elements to Model Effective Mechanical Properties of Metamaterial Cells Printed by Selective Laser Melting

Optimization of Bone Scaffold Porosity Distributions

Elasto-dynamic characterization of material extrusion infills using homogenization methods

A Novel Optimization Design Method of Additive Manufacturing Oriented Porous Structures and Experimental Validation