Process optimization of refill friction spot stir of AA6061-T6 aluminum alloy for thick plate
Di Jiang,I.N. Kolupaev,Wang HongFeng,Ge Xiaole
DOI: https://doi.org/10.1080/01694243.2024.2416048
IF: 2.431
2024-10-23
Journal of Adhesion Science and Technology
Abstract:To investigate the process parameters of refillable friction stir spot welding for AA6061-T6 aluminum alloy with a 3 mm plate thickness, and to extend the applicability of this technology, experiments were conducted using custom-made tools under varying rotational and penetration speeds. This study aimed to produce well-formed welds and analyze the metallurgical structure, tensile shear strength, and microhardness of the welded joints. The experiments were performed at rotational speeds of 1000, 1200, 1400, and 1600 rpm and penetration speeds of 20, 30, 40, and 50 mm/min. These conditions were found to facilitate effective refillable friction stir spot welding. The results indicated that at lower rotational speeds, the joints failed at the interface, while at higher speeds, failure occurred through the plug. Optimal tensile shear strength was achieved at a rotational speed of 1400 rpm and a penetration speed of 30 mm/min, with a peak force of 9.27 kN and a joint surface fracture mode. Microstructural examination revealed a significant refinement of grains in the weld zone compared to the base metal. Microhardness measurements showed a concentric ring pattern on the upper surface with higher hardness at the center, decreasing toward the edges. The cross-sectional hardness demonstrated a vertical gradient, being higher at the top and decreasing toward the bottom. Notably, the welded area exhibited signs of annealing with a reduced hardness compared to the base metal, where the maximum value was recorded as HV79.
materials science, multidisciplinary,engineering, chemical,mechanics