Abstract:The substructure design plays an important role in the capital expenditure as well as the dynamic performance of floating wind turbines (FWTs). To determine the most cost-effective hull shape and mooring configuration from various design concepts, this paper proposes an evaluation methodology based on long-term dynamic optimization. To make the long-term dynamic performance assessment computationally affordable in the iterative optimization process, the FWT responses are approximated by a Kriging surrogate model, which is established via regression analysis between representative met-ocean parameters and the corresponding short-term responses. The short-term responses in stochastic wind and waves are simulated by an efficient reduced-order model (ROM) with eight degrees of freedom (DoFs). The Kriging model is employed to derive the long-term performance indicators, e.g. the lifetime accumulative fatigue damage at tower base and fairleads, the peak platform motion and nacelle acceleration. The model effectiveness is confirmed by the verification campaign against OpenFAST. Afterwards, this model is implemented into a multi-objective optimization framework that aims to find out the Pareto optimal designs that have the best trade-off between long-term dynamic performance and manufacturing cost. The NSGA-II algorithm is adopted to explore the substructure design space, with the consideration of constraints related to the inherent properties as well as the dynamic performance of structures. This methodology is applied to two typical semi-submersible FWTs: the Y-shaped and the square-shaped concept. By comparing their Pareto fronts , it is found that the square-shaped semi-submersible is expected to be a more favourable substructure for our case study. Under the same level of manufacturing cost, the tower base fatigue of square-shaped concept is mostly 30%–50% lower than that of the Y-shaped. Hydrodynamics is the main cause of the fatigue difference between the two concepts. This work provides a decision basis on which FWT substructure design is employed as input to the detail design stage.

Concept Study for the Floater Type Selection on Floating Offshore Wind Turbines

Global sensitivity study on the semisubmersible substructure of a floating wind turbine: Manufacturing cost, structural properties and hydrodynamics

Preliminary Techno-Economic Study of Optimized Floating Offshore Wind Turbine Substructure

Driving Down Cost: A Case Study of Floating Substructure for A 10MW Wind Turbine

Systematic analysis of performance and cost of two floating offshore wind turbines with significant interactions

Evaluation of floating wind turbine substructure designs by using long-term dynamic optimization

Integrated Numerical Investigation of a 15 MW Semi-Submersible Wind Turbine at Moderate Water Depth

Comparison of dynamic response and levelized cost of energy on three platform concepts of floating offshore wind turbine systems

An experimental study on global motions and structural internal loads of a 5 MW floating wind turbine supported on a multi-segment semi-submersible hull in shallow water

Feasibility studies of a novel spar-type floating wind turbine for moderate water depths: Hydrodynamic perspective with model test

A NOVEL SEMI-SUBMERSIBLE FLOATING WIND TURBINE PLATFORM DESIGN BASED ON TUNED LIQUID COLUMN DAMPERS

Optimized Floating Offshore Wind Turbine Substructure Design Trends for 10–30 MW Turbines in Low-, Medium-, and High-Severity Wave Environments

Comparison of concrete and steel semi-submersible floaters for 10MW wind turbines

Conceptual design of a novel 10 MW T-Semi floating offshore wind turbine and mooring system for transitional water depths

A Novel Semi-Spar Floating Wind Turbine Platform Applied for Intermediate Water Depth

A Review of Numerical and Physical Methods for Analyzing the Coupled Hydro–Aero–Structural Dynamics of Floating Wind Turbine Systems

Buoyancy can ballast control for increased power generation of a floating offshore wind turbine with a light-weight semi-submersible platform

Numerical Study of an Innovative Concept for a Multibody Anti-Pitching Semi-Submersible Floating Wind Turbine

Optimization of a Lightweight Floating Offshore Wind Turbine with Water Ballast Motion Mitigation Technology

Dynamic response of a shallow-draft floating wind turbine concept: Experiments and modelling

Cost-based mooring designs and a parametric study of bridles for a 15 MW spar-type floating offshore wind turbine