3D radiative transfer modelling of fire impacts on a two-layer savanna system

M.I. Disney,P. Lewis,J. Gomez-Dans,D. Roy,M.J. Wooster,D. Lajas
DOI: https://doi.org/10.1016/j.rse.2011.03.010
IF: 13.5
2011-08-01
Remote Sensing of Environment
Abstract:We present a new, detailed three dimensional (3D) approach to modelling the pre- and post-fire reflectance of a two-layer savanna system modelled as heterogeneous overstory (tree) and understory (grass) layers. The models were developed from detailed field measurements of structural and radiometric properties made at experimental burn plots with varying canopy cover in the Kruger National Park, South Africa. The models were used to simulate 400–2500nm spectral reflectance at 10–500m spatial scale for various viewing and solar geometry configurations. The model simulations closely matched pre-fire and post-fire ground-based, helicopter and satellite remote sensing observations (all r2 values>0.95 except one post-fire case). The largest discrepancies between modelled and observed reflectances occurred typically at wavelengths greater than 1200nm for the post-fire simulations. The modelling results indicate that representation of overstory and understory structure and scattering properties are required to represent the burn signal in a typical savanna system. The described 3D modelling approach enables separation of the scattering contributions of the different scene components and is suited to testing and validating fire impact assessment algorithms at locations where the difficulty of obtaining both pre- and post-fire observations is a severe constraint.
environmental sciences,imaging science & photographic technology,remote sensing
What problem does this paper attempt to address?