Abstract:Background and objectives: It is desirable to minimize peripheral thermal damage during laser irradiation, since thermal damage to collagen and mineral compromises the bond strength to restorative materials in dentin and inhibits healing and osteointegration in bone. There were two primary objectives of this study. The first objective was to measure the degree of thermal damage peripheral to incisions in dentin produced with lasers resonant to the specific absorption bands of water, collagen, and hydroxyapatite with varying pulse duration using polarized-light microscopy (PLM). The second objective was to use synchrotron radiation infrared spectromicroscopy (SR-FTIR) to identify the specific chemical nature of the optical changes observed under PLM in the respective zones of thermal damage peripheral to the laser incisions. Study design/materials and methods: Precise incisions were produced in 3 x 3 mm2 blocks of human dentin using CO2 (9.6 microm), Er:YSGG (2.79 microm), and Nd:YAG (355 nm) lasers with and without a computer controlled water-spray. Optical coherence tomography (OCT) was used to obtain optical cross-sections of each incision to determine the rate of ablation. The peripheral thermal damage zone around each incision was analyzed using PLM and SR-FTIR. Results: Thermally induced chemical changes to both mineral and the collagen matrix were observed with SR-FTIR with a 10 microm spatial resolution and those changes were correlated with optical changes observed with PLM. Minimal (<10 microm) thermal damage was observed for pulse durations less than the thermal relaxation time (Tr) of the deposited laser energy, with and without applied water at 9.6 microm and with only applied water at 2.79 microm. For pulse durations greater than Tr, greater peripheral thermal damage was observed for both IR laser wavelengths with and without the water-spray. There was minimal thermal damage for 355 nm laser pulses less than Tr with and without applied water; however, extensive mechanical damage (cracks) was observed. Conclusions: High resolution SR-FTIR is well suited for characterization of the chemical changes that occur due to thermal damage peripheral to laser incisions in proteinaceous hard tissues. Sub-microsecond pulsed IR lasers resonant with water and mineral absorption bands ablate dentin efficiently with minimal thermal damage. Similar laser parameters are expected to apply to the ablation of alveolar bone.

Ti:sapphire femtosecond laser ablation of dental enamel, dentine, and cementum

High-Intensity Femtosecond Laser Ablation of Human Enamel and Dentin

Investigation of laser wavelength effect on the ablation of enamel and dentin using femtosecond laser pulses

Femtosecond Laser Ablation of Dentin and Enamel: Relationship Between Laser Fluence and Ablation Efficiency

Femtosecond Laser for Cavity Preparation in Enamel and Dentin: Ablation Efficiency Related Factors

Enamel and Dentin Exposed to Pulsed Nd∶YAG Laser

Ablation Efficiency of a Novel Thulium Fiber Laser: an in Vitro Study on Laser Setting and Fiber Usage.

Selectivity, efficiency, and surface characteristics of hard dental tissues ablated with ArF pulsed excimer lasers

Effects of fluence and scanning velocity on the ablation efficiency of dentin and enamel by femtosecond laser

High-speed scanning ablation of dental hard tissues with a λ = 9.3 μm CO2 laser: adhesion, mechanical strength, heat accumulation, and peripheral thermal damage

Precise femtosecond laser ablation of dental hard tissue: preliminary investigation on adequate laser parameters

[Femtosecond pulsed laser ablation of dental hard tissues with numerical control: a roughness and morphology study].

Influence of the hydration state on the ultrashort laser ablation of dental hard tissues

Optical penetration models for practical prediction of femtosecond laser ablation of dental hard tissue

Dental hard tissue ablation using mid-infrared tunable nanosecond pulsed Cr:CdSe laser

Fs‐laser Ablation of Teeth is Temperature Limited and Provides Information about the Ablated Components

Ablation Of Crystalline Oxides By Infrared Femtosecond Laser Pulses

Ablation induced by femtosecond laser in sapphire

Peripheral thermal and mechanical damage to dentin with microsecond and sub-microsecond 9.6 microm, 2.79 microm, and 0.355 microm laser pulses

Hard tissue ablation with a spray-assisted mid-IR laser

Effects of Yb:KYW thin-disk femtosecond laser ablation on enamel surface roughness