Abstract:The objective of this work is a dilatometric study of Al + 0.1% of multiwall carbon nanotubes nanocomposite material (NCM) in three directions: X - parallel to the rolling direction; Y - perpendicular to the rolling direction and (Z) perpendicular to the ribbon plane. NCM specimens were made in the form of a 0.1-mm-thick ribbon. The temperature range used for measurements was 20°C to 600°C. The obtained results show that presence of nanotubes affects the thermal expansion coefficient (TEC) measured in different directions. αx(T) and αy(T) - TEC plots as a function of temperature along X and Y directions, respectively - have substantially the same shape and overlap in the area of 400°C. The expansion along X-axis becomes greater than along Y-axis below this temperature value. It is clear that the coefficient αz(T) is lower than αx(T) and αy(T) over the entire temperature range. The expansion along Z-axis is smaller compared to that along X- and Y-axes. This behaviour suggests that there is a strong interatomic interaction along this direction (Z). αz(T) becomes monotonous and constant and is equal to 8 × 10(-6)°C(-1) at temperatures above 300°C. Such order of magnitude had not been obtained in earlier studies of aluminium alloys. The obtained TEC shows high anisotropy, which grows with the increase of temperature. The heat flow (differential scanning calorimetry, (DSC)) of Al + 0.1% carbon nanotubes (CNT) NCM is more intense compared to that of pure aluminium produced in similar conditions. The two representative curves have similar shape and are almost entirely overlapped. The thermogravimetry results confirm those of DSC. The Raman spectrum of this nanomaterial shows that intensity of G and D bonds is significantly increased compared to that of the pure material. The infrared diagram also confirms that in this case the mentioned bonds are more intensive NCM. The tensile strength measurements (σB) of the studied NCM also demonstrate that its value increases from 140 ± 10 MPa for Al without nanotubes to 200 ± 10 MPa for NCM.

Negative Thermal Expansion of Carbon Nanotube Bundles

Coupled Thermomechanics Of Single-Wall Carbon Nanotubes

Thermal Conductivity Of Configurable Two-Dimensional Carbon Nanotube Architecture And Strain Modulation

Thermal Expansion of Single Wall Carbon Nanotubes

Transverse vibrations of double-walled carbon nanotubes under compressive axial load

Simulation of mechanical and physical properties of a carbon nanotubes bundle under the transverse compression using a chain model with the reduced number of degrees of freedom

Thermal expansion in carbon nanotubes and graphene: nonequilibrium Green's function approach

Negative Thermal Expansion of Ultrathin Metal Nanowires: A Computational Study

Interfacial Thermal Conductance of Buckling Carbon Nanotubes

Mechanical and Thermal Properties of Graphyne-Coated Carbon Nanotubes: a Molecular Dynamics Simulation on One-Dimensional All-Carbon Van Der Waals Heterostructures

Ultrahigh Convergent Thermal Conductivity of Carbon Nanotubes from Comprehensive Atomistic Modeling

Nonlinear Thermal Conductance In Single-Wall Carbon Nanotubes: Negative Differential Thermal Resistance

Chain Model for Carbon Nanotube Bundle under Plane Strain Conditions

Torsional Properties of Bundles with Randomly Packed Carbon Nanotubes

Negative Thermal expansion of pure and doped Graphene

Graphene-Nanotube 3d Networks: Intriguing Thermal and Mechanical Properties

Investigation into the influence of CNTs configuration on the thermal expansion coefficient of CNT/Al composites

Strain controlled thermomutability of single-walled carbon nanotubes.

Nanoscale Heat Transport of Vertically Aligned Carbon Nanotube Bundles for Thermal Management Applications

Thermal analysis of Al + 0.1% CNT ribbon

Computationally Guided Design of Large-Diameter Carbon Nanotube Bundles for High-Strength Materials