Abstract:Removing heat from heat generating sources at a high heat flux is a serious challenge in many industries, e.g., high power electronics. Towards this end, this numerical study demonstrates the performance of a new heat sink design that integrates high conductivity fins within high thermal conductivity phase change materials (PCM) i.e., Gallium (Ga) metal. The bases of the fins are attached to the bottom heat sink base that receives heat directly from the hot source that requires cooling whereas the upper parts of the fin are exposed to the ambient. Two heat flux levels from the heat source are considered i.e., 3 and 10 W/cm2. A major novelty aspect of this work is rooted in the way fins are installed in the heatsink such that they facilitate creating temperature imbalance between different regions of the molten PCM hence inducing effective natural circulations that lead to clear enhancement in heat removal from the hot sink base. As such, our proposed fins are not merely a way to enhance thermal conductivity of used PCM. In addition to this, they have by far more reaching implications by forming a second heat escape path from the hot base to the outer surroundings, in addition to direct heat transfer from the hot sink base into molten PCM and subsequently to the solid PCM above it. The upper fins parts exposed to the cool ambient surroundings play a crucial role in respect to the above by sucking heat from bottom hotter fin parts. The aforementioned buoyancy-driven circulating motions augmented by induced temperature imbalance caused by the fins smooth out temperature gradients and alleviate peak temperatures at the sink base. The levels of temperatures attained in the presence of the fins were found to be much lower than cases with no fins. The effectiveness of buoyancy was quantified by performing simulations with and without buoyancy effects. The role played by the fins becomes so decisive in limiting peak temperatures especially under the higher heat flux levels.

A heat sink integrating fins within high thermal conductivity phase change material to cool high heat-flux heat sources

Transient Performance of a Thermal Energy Storage-Based Heat Sink Using a Liquid Metal As the Phase Change Material

Investigation of enhanced PCM heat sink design under extreme thermal conditions for high-heat-generating electronic devices

Numerical simulation of thermal performance of heat sink augmented with phase change material PCM integrated with solid and aluminum metal foam fins

Experimental and Numerical Study of Conical-Shaped Pin Finned Heat Sink with PCM Material

Efficient Thermal Energy Management of Hollow Pin Fin Heat Sinks with and without Phase Change Material

Experimental and numerical investigations on the intermittent heat transfer performance of rectangular cavity plate fin phase change material based heat sink

Numerical and experimental study of inverse natural convection heat transfer for heat sink in a cavity with phase change material

Thermal performance of phase change material–based heat sink for passive cooling of electronic components: An experimental study

Thermal Performance of a Phase Change Material-Based Heat Sink Subject to Constant and Power Surge Heat Loads: A Numerical Study

Investigation of Phase Change Material Integrated With High Thermal Conductive Carbon Foam Inside Heat Sinks for Thermal Management of Electronic Components

Thermal performance assessment of phase change material for electronic cooling: An experimental investigation

Thermal performance of a PCM heat sink under different heat loads: An experimental study

Heat management in sonochemical reactor using fins-PCM integrated system: Unveiling the influence of the sonicated volume

Numerical investigation and optimisation of solid–solid phase change material composite-based plate-fin heat sink for thermal management of electronic package

Finned Heat Pipe Assisted Low Melting Point Metal PCM Heat Sink Against Extremely High Power Thermal Shock

Experimental Study on the Thermal Performance of a Finned Metal Foam Heat Sink with Phase Change Material

Effects of Melting Temperature and the Presence of Internal Fins on the Performance of a Phase Change Material (Pcm)-Based Heat Sink

An experimental study for thermal management using hybrid heat sinks based on organic phase change material, copper foam and heat pipe

Thermodynamics analysis of fins integration in sono-PCM reactor: Sonic power influence

Melting Enhancement in a Triple-Tube Latent Heat Storage System with Sloped Fins