Abstract:In masonry construction, the most commonly used building unit all over the world is the burnt clay brick. Adding waste materials in certain percentages to these bricks helps in eliminating the environmental burden occurring in the form of excessive waste accumulation on open land sites, leading to sustainable and economical construction. This research program aimed to examine the feasibility of using waste marble powder (WMP) and sugarcane bagasse ash (SBA) in the manufacturing of clay bricks. WMP was collected from local marble cutting workshops, whereas SBA was prepared by burning the waste sugarcane obtained from various sugar mills in the local area. Brick specimens incorporating 5%, 10%, 15%, and 20% of hybrid WMP and SBA were prepared at a local brick kiln. Burnt clay bricks were transported to the laboratory, and their mechanical and durability properties were evaluated. A reduction in weight per unit area of brick specimens incorporating waste materials was observed, allowing them to be easily handled and transported. Decreased compressive strength was due to the addition of waste materials in comparison with conventional clay bricks. However, waste percentages up to 15% satisfied the criteria for the minimum compressive strength as per the Building Code of Pakistan (BCP). All tested samples showed flexural strength greater than 0.65 MPa. Tested bricks incorporating 10% and 20% of waste materials had water absorption values of 18% and 21%, respectively, which are higher than that of conventional clay bricks. Moreover, bricks incorporating waste materials exhibited a higher initial rate of absorption than conventional clay brick; therefore, such bricks need to be wet well before use in masonry construction. Brick specimens showed less than 1% weight loss, and bricks exhibited no signs of distress and cracking after 50 freeze-thaw cycles. A decrease in compressive strength was observed due to sulphate exposure. However, specimens with 10% waste materials still satisfied the minimum compressive strength requirement of BCP. Based on this study, it can be concluded that bricks with up to 10% hybrid waste materials (WMP and SBA) will assist in the environmental issues of these wastes, leading to more sustainable and economical masonry construction.

Design analysis of a machine for manufacturing of bricks from industrial waste: simulations and experiments

Review of Solid Waste Resource Utilization for Brick-making

Mechanical properties optimization and cost analysis of agricultural waste as an alternative in brick production

Analysing the Effectiveness of Municipal Wastewater Sludge, Bagasse Ash, Rice Husk Ash and Plastic Waste Powder for Manufacturing Bricks

Waste-Based Bricks: Evaluation of Strength Behaviour of Bricks Containing Different Waste Materials as an Additive

MANUFACTURING OF CLAY BRICKS BY USING Water Treatment Plant SLUDGE

Study on preparation of brick blocks by using construction waste and sludge

Experimental investigation on the utilization of plastic waste and construction demolition waste in brick manufacturing.

Manufacturing of Clayey Bricks by Synergistic Use of Waste Brick and Ceramic Powders as Partial Replacement of Clay

Robotic mechanical design for brick-laying automation

Machine learning optimization of bio-sandcrete brick modelling using response surface methodology

Automatic Brick Masonry System and Its Application in On-site Construction

(re)thinking the brick: digital tectonic masonry systems

Utilization of Waste Plastic in Manufacturing of Bricks

An investigation of various properties of hybrid bricks using Natural fibers and waste fiber-based materials

Manufacturing of Clay Bricks Using Hybrid Waste Marble Powder and Sugarcane Bagasse Ash: A Sustainable Building Unit

An Experimental Investigation of Mechanical Properties in Clay Brick Masonry by Partial Replacement of Fine Aggregate with Clay Brick Waste

Manufacturing fired clay brick using fly ash and M−Sand

Developing fired clay bricks by incorporating scrap incinerated waste and river dredged sediment

Design and Analysis of Material Handling System

Mechanical behavior, petrography and microstructural analysis of mining waste recycled bricks