Abstract:We report here the first coupling of fast GC to IRMS, in a system capable of 250 ms peak widths (fwhm) at 1 mL/min flow rates, one-fifth as narrow as any previously reported GCC-IRMS system. We developed an optimized postcolumn interface that results in minimal peak broadening, using a programmable temperature vaporization injector in place of a rotary valve or backflush system to divert solvent, a narrow capillary combustion reactor followed by a cryogenic water trap with narrow-bore (< 0.20 mm We transfer lines, and a narrow W. open split to the IRMS directly inserted into the column effluent. Quantitative combustion was demonstrated with CH4 injections. A comparison of CO2 injections with different fwhm peak widths (250, 2500, and 7500 ms) showed similar precisions, SD(delta C-13) = 0.2-0.3 parts per thousand, for injections of > 600 pmol C on column; precision for the narrow peaks (250 ms) was considerably better for injections < 150 pmol C on column. SD(delta C-13) < 1 parts per thousand was achievable for injections of 5-15 pmol on column for 250 ms wide peaks, 10-fold better precision than 2500 ms wide peaks, and within a factor of 3 of the counting statistics Emit For a mixture of 15 fatty acid methyl esters (FAME), 1.5 nmol C of each on column yielded typical SD(delta C-13(pdb)) = 0.4 parts per thousand for fast GC and 0.5%o for conventional GC. For 14 of the 15 FAME, delta C-13 values between the two systems were within 1.5 parts per thousand and not significantly different Fast GCC-IRMS required one-third the run time (450 s vs 1400 s) to achieve comparable resolution. Mean peak widths for fast GCC-IRMS of the FAME were 720 ins, compared to 650 ms by fast GC with flame ionization detection. At a 15-fold dilution (100 pmol C on column for each FAME), fast GCC-IRMS achieved -2-fold better precision and accuracy than similar injections on conventional GCC-ERMS. Finally, a mixture of 10 steroids (similar to 7 nmol C (100 ng) each on column) was analyzed with mean precision of SD)(delta C-13) = 0.2 parts per thousand in 620 s by fast GCC-IRMS, while conventional GCC-IRMS required 1200 s and achieved poorer resolution. delta C-13 values for the two system were similar (Delta delta C-13 <=:5 2 parts per thousand for all steroids), indicating that accuracy is not compromised. In summary, fast GCC-IRMS can achieve similar precision to conventional GC with considerable time savings for standard sample sizes (> 1 nmol C) and achieves modest precision (similar to 1 parts per thousand) near the counting statistics limit on low level components.

Can gas chromatography combustion isotope ratio mass spectrometry be used to quantify organic compound abundance?

Fast gas chromatography combustion isotope ratio mass spectrometry.

Comparing Stable Isotope Enrichment By Gas Chromatography With Time-Of-Flight, Quadrupole Time-Of-Flight, And Quadrupole Mass Spectrometry

Measurements of position-specific carbon isotopic compositions in propane by on-line Gas Chromatography-Pyrolysis-Gas Chromatography-Isotope Ratio Mass Spectrometer (GC-Py-GC-IRMS) and its preliminary application

A GC/C/IRMS-based method for position-specific carbon isotopic analysis of saturated long chain fatty acids

Mapping and quantifying isomer sets of hydrocarbons (≥ C 12 ) in diesel fuel, lubricating oil and diesel exhaust samples using GC &times GC-ToFMS

CHNSO Elemental Analyses of Volatile Organic Liquids by Combined GC/MS and GC/Flame Ionisation Detection Techniques with Application to Hydrocarbon-Rich Biofuels

Mapping and Quantifying Isomer Sets of Hydrocarbons ( ≥ C12) in Diesel Exhaust, Lubricating Oil and Diesel Fuel Samples Using GC × GC-ToF-MS

Development of New Method of Δ13c Measurement for Trace Hydrocarbons in Natural Gas Using Solid Phase Micro-Extraction Coupled to Gas Chromatography Isotope Ratio Mass Spectrometry.

Isotope-labeling in situ derivatization and HS-SPME arrow GC-MS/MS for simultaneous determination of fatty acids and fatty acid methyl esters in aqueous matrices

Carbon-13-isotopomics and metabolomics of fatty acids from triacylglycerols: overcoming the limitations of GC-C-IRMS for short- and medium-acyl chains

Liquid chromatography combined with mass spectrometry for 13C isotopic analysis in life science research

Quantification of phospholipid fatty acids by chemical isotope labeling coupled with atmospheric pressure gas chromatography quadrupole- time-of-flight mass spectrometry (APGC/Q-TOF MS).

Quantitative NMR Spectroscopy for the Analysis of Fuels: A Case Study of FACE Gasoline F

Exploring the Use of Gas Chromatography Coupled to Chemical Ionization Mass Spectrometry (GC-CI-MS) for Stable Isotope Labeling in Metabolomics

Measurement of Carbon and Hydrogen Isotopes of Natural Gas Hydrate-Bound Gases by Gas Chromatography-Isotope Ratio Mass Spectrometry

Using solid-phase extraction to facilitate a focused tile-based Fisher ratio analysis of comprehensive two-dimensional gas chromatography time-of-flight mass spectrometry data: comparative analysis of aerospace fuel composition

Identifying and quantifying contaminants contributing to endogenous analytes in gas chromatography/mass spectrometry

Total alkylated polycyclic aromatic hydrocarbon characterization and quantitative comparison of selected ion monitoring versus full scan gas chromatography/mass spectrometry based on spectral deconvolution.

Establishing the Accuracy of Position-Specific Carbon Isotope Analysis of Propane by GC-pyrolysis-GC-IRMS.

Dissimilarity analysis and automatic identification of monomethylalkanes from gas chromatography mass spectrometry data 1. Principle and protocols.