Abstract:Numerous adsorbents have been applied for Heavy Metals (HMs) removal from contaminated water. The aim of this review was to critically analyze the status of research in HMs detection and adsorption, focusing on the adsorption approaches for better defining the corresponding future challenges and their potential solutions. Present research demonstrates the promising outlook for using remote sensing technology in the preliminary selection of contaminated areas before final HMs detection using spectrometry, microwave or electrochemical sensors. Adsorption can then be applied in treating HMs contaminated water due to its high effectiveness and low-cost. Natural zeolites showed 90 %-100 % Pb2+, 2 + , 95 % Cd2+ 2 + and 100 % Cu2+ 2 + removal from water, their effectiveness is affected by initial pH, and adsorbent dosage and size. As synthesized zeolites, zeolitized pumice waste showed 100-500 mg/g of HMs adsorption at pH 4.0-5.0, 57 mg/g Zn2+ 2 + by oxalate-loaded zeolites and 682 mg/g Pb2+ 2 + and 122 mg/g Ni2+ 2 + by zeolite nanoparticle impregnated polysulfone membrane from wastewater. Activated carbon exhibited 99 %-100 % Hg2+, 2 + , 93 % Cu2+ 2 + and 99 % Co2+ 2 + removal from water under acidic environment. Biochar is more ecofriendly and demonstrated its effectiveness in removing up to 98 % Cd2+, 2 + , 97 % Cu2+, 2 + , 99 % Pb and 94 % Zn2+ 2 + from water. Chitosan showed 755 mg/g Pb2+, 2 + , 979 mg/g Cd2+ 2 + and 877 mg/g Cu2+ 2 + removal at pH 2.0-6.0 from wastewater. Peat moss exhibited 96 % Cu2+ 2 + and 50 % Cr6+ 6 + removal from wastewater at lower pH. Similarly, bioremoval showed 143 mg/g Zn2+ 2 + (algae) adsorption at pH 6.0 in, and 90 % Cr6+ 6 + and 98 % Cu2+ 2 + removal by biomass ash. Recently, carbon, magnetic and titanium nanotubes/composites have shown high efficiency and selectivity in HMs removal, but their preparation is often more expensive than their counterparts. In addition, adding enhancement solutions promoted HMs adsorption and reduced treatment time. Chemical precipitation demonstrated feasibility to recycle and recover extracted HMs and spent adsorbent. This review demonstrates the need for highly selective and efficient adsorbent, and guides the future researchers to make funtionalized and organic-inorganic composite HMs adsorbents.

Removal of Heavy Metal Ions from Water Using Nano-Barium Strontium Titanate Immobilized on the Silica Gel G as an Adsorbent

Enhanced Removal of Nickel(ii) from Water by Utilizing Gel-Type Nanocomposite Containing Sub-5 Nm Hydrated Manganese(iv) Oxides

Recent Progress on the Adsorption of Heavy Metal Ions Pb(II) and Cu(II) from Wastewater

Metastable Nano-Zirconium Phosphate Inside Gel-Type Ion Exchanger for Enhanced Removal of Heavy Metals.

Efficient heavy metal removal from water by alginate-based porous nanocomposite hydrogels: The enhanced removal mechanism and influencing factor insight

Adsorption of heavy metal ions by iron tailings: Behavior, mechanism, evaluation and new perspectives

Adsorption Behavior of Heavy Metal Ions by Hybrid Inulin-TEOS for Water Treatment

Application of Ionic Liquid Crosslinked Hydrogel for Removing Heavy Metal Ions from Water: Different Concentration Ranges with Different Adsorption Mechanisms

Selective adsorption of heavy metals from water by a hyper-branched magnetic composite material: Characterization, performance, and mechanism

Green Synthesis of Reusable Adsorbents for the Removal of Heavy Metal Ions

Porous sodium alginate/cellulose nanofiber composite hydrogel microspheres for heavy metal removal in wastewater

Separation and reutilization of heavy metal ions in wastewater assisted by p-BN adsorbent

Fabrication of Sodium Alginate Porous Scaffolds for Heavy Metal Ion Removal from Aqueous Solution

Highly efficient removal of bivalent heavy metals from aqueous systems by magnetic porous Fe3O4-MnO2: Adsorption behavior and process study

Alginate-based adsorbents with adjustable slit-shaped pore structure for selective removal of copper ions

Engineering and Optimization of Nano- and Mesoporous Silica Fibers Using Sol–gel and Electrospinning Techniques for Sorption of Heavy Metal Ions

Removal of Trace Heavy Metal from Surface Water by Coagulation Enhanced by Nanosized MnO2

Amidation modified hollow composite microspheres as a self-floating adsorbent for efficient capture of anionic dye DB86 and heavy metal nickel (II)

Gellan Gel Beads Containing Magnetic Nanoparticles: an Effective Biosorbent for the Removal of Heavy Metals from Aqueous System

Heavy Metals Detection and Removal from Contaminated Water: A Critical Review of Adsorption Methods

Novel Sustainable Adsorbents Prepared by Banana/Pomegranate Peels via EDTA Grafting for Effective Removal of Cd(II), Co(II), Mn(II), and Ni(II) from Sewage System