Boost in Solid‐State Photon Upconversion Efficiency through Combined Approach of Melt‐Processing and Purification

Steponas Raišys,Saulius Juršėnas,Karolis Kazlauskas
DOI: https://doi.org/10.1002/solr.202100873
IF: 9.1726
2022-02-12
Solar RRL
Abstract:Realization of efficient photon upconversion (UC) mediated by triplet-triplet annihilation (TTA) in a solid state is a great challenge, even though order of magnitude higher efficiencies are routinely reported in a solution/liquid state. To address this issue in a typical emitter/sensitizer UC system, we introduce the combined approach based on i) thorough emitter purification for reduced exciton quenching and ii) UC film fabrication via melt-processing for attaining large emitter concentrations with suppressed aggregation. Emitter purification via vacuum sublimation is shown to reduce the number of both singlet and triplet quenchers as confirmed by fluorescence and UC emission quantum yield measurements along with the respective transient measurements performed on nanosecond- and millisecond-time domains. Application of this approach to the benchmark TTA-UC system DPA/PtOEP is demonstrated to yield record-high UC efficiency (=8±1%, out of maximum 50%) achieved at 40 wt% of DPA homogeneously dispersed in PMMA host. Importantly, such high efficiency is accomplished in large-area amorphous films, the most preferred for practical applications, and featuring low UC threshold (=5 mW/cm2) that is close to the solar irradiance. The presented approach describes the guidelines for boosting UC efficiency in the solid state, and in general, is applicable to any conventional TTA-UC system.This article is protected by copyright. All rights reserved.
energy & fuels,materials science, multidisciplinary
What problem does this paper attempt to address?