Abstract:Power plants are a major source of CO2 emissions in the environment, which cause global warming; due to this issue, CO2 capture from hydrocarbon fuels is one of the key technology options to reduce greenhouse gases. Pre-combustion capture of CO2 in the combined gas and steam turbine cycle has been investigated in this paper. The first step in the pre-combustion method is to react the fuel with oxygen, which comes from the air separation unit and produces a mixture of hydrogen and carbon monoxide. The CO is converted to CO2 in a water-shift reactor, and a physical absorbent removes the CO2; a hydrogen-rich fuel is produced, which can be burnt in a gas turbine with minimal CO2 emissions. This paper presents a thermodynamic cycle analysis, where pre-combustion CO2 capture is applied in a combined cycle where the main goal is to reduce the CO2 emission into the atmosphere. The main parameters are varied to examine the influence on cycle performance. The cycle performance results for the combined cycle with CH4 as fuel are presented and compared to the combined cycle with precombustion CO2 capture, both with and without Nitrogen injection into the compressor. An exergy analysis is carried out to determine which case has more exergy destruction. The results indicate that at 45 oC the combined cycle efficiency is raised by around 3 % when the pre-combustion CO2 capture without Nitrogen injection into the compressor is used, and the power output has been increased by 29 %. The performance of combined cycle with CO2 capture can be further enhanced by the N2 acquired from the air separation process and injected into the compressor’s middle stage. The results demonstrate a good improvement in the performance; the power output increases by 48 % and efficiency by 4.2 %. However, exergy destruction is increased when the CO2 capture, both with and without N2 injection into the compressor is used. Nevertheless, pre-combustion capture requires large monetary investment for a new-build plant where also the CO2 emission is reduced by 100 %.

Energy-exergy analysis of compressor pressure ratio effects on thermodynamic performance of ammonia water combined cycle

Advanced Exergy Analyses of an Ejector Expansion Transcritical Co2 Refrigeration System

Study on Usage Efficiency of Single Screw Compressor's Shaft Power Based on Exergy Analysis Method

Exergoeconomic Analysis of A Combined Cycle System Utilizing Associated Gases from Steel Production Process Based on Structural Theory of Thermoeconomics

Thermodynamic Analysis of a New Combined Cooling and Power System Using Ammonia–water Mixture

Thermoeconomic analysis and multiobjective optimization of a combined gas turbine, steam, and organic Rankine cycle

Energy-Exergy Analysis of Combined ReheatingRegenerative Rankine Cycle using Entropy Generation Principle

Energy, Exergy, and Economic Analysis of a New System for Simultaneous Power Production and Cooling Operating with an Ammonia–Water Mixture

Thermal performance of gas turbine power plant based on exergy analysis

Exergy and Pinch Analysis of Diesel Engine Bottoming Cycles with Ammonia-Water Mixtures As Working Fluid - Part I: Assumptions and System Description

Advanced exergy and advanced exergoeconomic analyses of the partial heating supercritical CO2 power cycle for waste heat recovery

Effect of Flow Losses in Heat Exchangers on the Performance of Organic Rankine Cycle

COST BENEFIT ANALYSIS OF WASTE HEAT TO POWER OPTION FOR MULTISTAGE AIR COMPRESSOR

Exergy destruction analysis of a power generation system utilizing the cold energy of LNG

Energy, Exergy & Environmental Analysis of a Combined Cycle with Pre-combustion CO2 Capture and N2 Injected into the Compressor of the Gas Turbine

A Modified Exergy Analysis Method for Vapor Compression Systems: Splitting Refrigerant Exergy Destruction

An Efficient Ammonia-Water Power Cycle in Low Temperature Waste Heat Application

Thermodynamic Analysis for LNG Combined Cycle Power Plants

Advanced exergy analysis of recompression supercritical CO2 cycle

Performance Analysis and Optimization of a Combined Cooling and Power System Using Low Boiling Point Working Fluid Driven by Engine Waste Heat

Examination of the performance effects of refrigerants in a multistage refrigeration cycle using advanced exergy analysis