Morphological and mechanical properties of Miscanthus in relation to harvesting, lodging, and growth conditions

Karl Kaack,Kai-Uwe Schwarz
DOI: https://doi.org/10.1016/s0926-6690(01)00078-4
IF: 6.449
2001-09-01
Industrial Crops and Products
Abstract:Field experiments with Miscanthus ‘giganteus’ and Miscanthus ‘sinensis’ including studies concerning effects of harvest time, lodging, pruning, and fertilisation on morphological and mechanical properties were conducted. Stem length increased from the first to the second harvest and then decreased due to natural internode abscission starting at the upper internodes. An average of three internodes was lost from the stems. The lengths of internodes 2 and 4 were independent of harvest time. However, the lengths of the upper internodes were at a minimum at harvest times 2–4. The internode length increased from the second to the fourth internode and then followed by a decrease. Outer diameter, inner diameter, culm wall thickness, moment of inertia, modulus of elasticity, and flexural rigidity decreased from the lower to the upper nodes and internodes. Average internode length, culm wall thickness, internal diameter, outer diameter, moment of inertia (I) of internodes, and modulus of elasticity of internodes were not influenced by harvest time. Moment of inertia was high and modulus of elasticity was low for internodes compared to the nodes. However, the flexural rigidity was highest for internodes. The measured values for modulus of elasticity ranged from 2–8 GPa. Pruning of the crop and use of a minimum of nitrogen fertilizer reduced the risk of lodging.
agronomy,agricultural engineering
What problem does this paper attempt to address?