Abstract:Supercapacitors are gaining increasing attention for complementing or replacing batteries and they are highly desirable in applications where high power and long cycle life of energy storage devices are needed. Activated carbons (AC) are the most promising electrodes in the supercapacitor industry presenting the best performances/cost compromise. Recently, graphene, with a two dimensional carbon nanostructure, has emerged as a new class of promising electrode material in supercapacitors, due to its outstanding properties such as high electric conductivity, high surface area, good mechanical properties and chemical inertia. Among the various approaches to producing graphene materials, here we focus on reduced exfoliated graphene oxide (r-GO) derived from chemically synthesised graphene oxide (GO). However, the graphene materials prepared by either chemical or thermal reduction of the graphene oxide always exhibits a relatively low electrochemical performance due to the agglomeration of graphene sheets and does not reflect the intrinsic capacitance of an individual graphene nano-sheet. To exploit the potential electrochemical applications for graphene, a particularly attractive option is to design and develop composites of graphene with other materials. In this study, we present an approach to synthesize a composite of reduced graphene oxide (r-GO) with activated carbon and its use as an electrode material in supercapacitors. To the best of our knowledge, a few studies on the preparation of GO/AC composites have been reported so far. Graphene oxide was synthesised using vein graphite by a modified Hummers method and then mixed with activated carbon to prepare a homogeneous composite. The composite was thermally reduced to convert GO in to r-GO. The morphology and chemical structure of the materials were characterized by means of Electron microscopy, Raman spectroscopy, X-ray diffraction and Fourier Transform Infrared Spectroscopy. Thermal properties were investigated using Thermo Gravimetric Analysis. The electrochemical properties of as obtained composites with different mass ratios were investigated, together with their individual components (GO, r-GO and AC) for comparison. For electrochemical characterisation, two-electrode symmetrical supercapacitor cells were constructed and characterized by cyclic voltammetry and electrochemical impedance spectroscopy. Tetraethylammonium tetrafluoroborate (TEABF4) in Propylene Carbonate (PC) was used as the electrolyte. The CV curves were measured from 0 to 1 V with various scan rates ranging from 10 to 1000 mV s −1 and the CV data were used to calculate the specific capacitances of the electrodes. The results showed that the as-prepared composites exhibited an improved electrochemical performance as compared to pure r-GO or AC. This improvement can be attributed to the synergistic effect of AC and r-GO. The maximum specific capacitance observed for the r-GO/ AC composite was 115.6 F/g at a scan rate of 10 mV s -1 . The near-rectangular CV curves at ultrafast sweep rate of 1000 mV s -1 indicated very efficient charge transfer within the composite electrodes. The incorporation of rGO into AC, not only provides the vacancies to accommodate ions, but also forms a promising network structure to conductively bridge the spaces between the AC particles, which can facilitate rapid transport of the electrolyte ions within the electrode materials, leading to a high-rate performance of the supercapacitor. Within the composite, r-GO plays the role of both the binder and the conductive additive increasing the specific capacitance and the power density of the devices.

Enhanced electrochemical performance of porous activated carbon by forming composite with graphene as high-performance supercapacitor electrode material

Mn0.5co2.5o4 Nanofibers Sandwiched in Graphene Sheets for Efficient Supercapacitor Electrode Materials

Synthesis of porous graphene/activated carbon composite with high packing density and large specific surface area for supercapacitor electrode material

Graphene Oxide and Activated Carbon Composites for High-Power Supercapacitors

Preparation of Hierarchically Porous Carbon Nanosheet Composites with Graphene Conductive Scaffolds for Supercapacitors: an Electrostatic-Assistant Fabrication Strategy

Boosting the Energy Storage Densities of Supercapacitors by Incorporating N-doped Graphene Quantum Dots into Cubic Porous Carbon

Control of Nano Grains and Wide Carbocyclic Layer Space of Forming Active Carbon with Extraordinary Capacitance Characteristics in Supercapacitors

Porous carbon derived from cashew nut husk biomass waste for high-performance supercapacitors

A Novel and Facile Synthesis Approach for a Porous Carbon/graphene Composite for High-Performance Supercapacitors

Performance-Enhanced Activated Carbon Electrodes for Supercapacitors Combining Both Graphene-Modified Current Collectors and Graphene Conductive Additive

Surface Modification by Graphene Oxide: an Efficient Strategy to Improve the Performance of Activated Carbon Based Supercapacitors

Graphitic porous carbon with multiple structural merits for high-performance organic supercapacitor

Electrochemical properties of graphene nanosheet/carbon black composites as electrodes for supercapacitors

High-Performance Supercapacitors Based on Graphene/Activated Carbon Hybrid Electrodes Prepared Via Dry Processing

Preparation of biomass composite activated carbon based supercapacitor materials and their application in energy storage devices

Coal Tar Residues-Based Nanostructured Activated Carbon/fe3o4 Composite Electrode Materials for Supercapacitors

Preparation and Application of Graphene and Derived Carbon Materials in Supercapacitors: A Review

Scalable Preparation of Hierarchical Porous Activated Carbon/graphene Composites for High-Performance Supercapacitors

Boosting the supercapacitor performances of activated carbon with carbon nanomaterials

Controlling and optimizing the morphology and microstructure of 3D interconnected activated carbons for high performance supercapacitors

Facile synthesis of graphene sheets intercalated by carbon spheres for high-performance supercapacitor electrodes