Abstract:External gear pumps are among the most popular fluid power positive displacement pumps; however, they often suffer from excessive flow pulsation transmitted to the downstream circuit. To meet the increasing demand of quiet operation for modern fluid power systems, it is necessary to give a physically sound method of analyzing the operation of a volumetric pump. The analysis of the basic approach used by the majority of researchers for calculating the flow rate of a gear pump by E.M. Yudin is presented. The article presents a new method for analyzing the operation of volumetric pumps. The method is suitable for the pumps whose dynamic characteristics should be considered according to the model of an equivalent source of flow fluctuations by V.P. Shorin. The method is based on wave theory, the method of hydrodynamic analogies and the impedance method, where the pump is considered according to the model in lumped parameters. The method consists in determining the pressure pulsations at the pump output in bench systems with known dynamic characteristics and recalculating the pump flow rate in pulsations. Computational dynamic models of bench systems in lumped parameters are proposed for subsequent use in dynamic tests of pumps in the form of equivalent sources of fluid flow fluctuations. We give recommendations for the formation of test bench systems with a throttle, a cavity and a pipeline at the pump output. Using the example of an external gear pump with a working volume of 14 cm3/rev, the implementation of the proposed method is considered. The pump's own pulsation characteristic of the flow rate in a bench system with an "infinitely long" pipeline along two harmonic components of the spectrum is determined, and a test of the method based on the method of determining the instantaneous flow rate by R.N. Starobinskiy is proposed. It is shown that, according to the proposed method and the method of R.N. Starobinskiy, the divergence of the amplitudes of flow pulsations does not exceed (5–10)%. The high degree of coincidence of the results confirms that the external gear pump in question should be considered according to the equivalent source of flow fluctuations model.

Research on Seawater Hydraulic Internal Ball Gear Pump

Experimental Research on Performance of Water Hydraulic Internal Gear Pump

Analysis and Experimental Research on Efficiency Characteristics of a Deep-Sea Hydraulic Power Source

Theoretical Analysis of a Water Hydraulic Internal Ball Gear Pump

Investigations of the Micro Surface Shape for the Gear-Shaft/journal-bearing Interface in Water Hydraulic Internal Gear Pumps

Virtual prototype technology for axial piston pumps used in seawater desalination

Research on the Hydraulic Power Take-off Unit of a Hybrid Wave Energy Converter

The development of an axial piston pump prototype for seawater desalination and its application

Simulation on the dynamic pressure and flow of the seawater desalination axial piston pump

Distribution Performance Analysis and Experimental Research on the Port Plate Pairs of Low Speed High Torque Seawater Hydraulic Motor

Low Leakage and High Volumetric Efficiency Research of Seawater Plunger Pump

Motion Modelling of the Floating Bushing in an External Gear Pump Using Dimensional Analysis

Experimental and Numerical Analysis of a Self-Circulating Oil Bearing System for Gear Pumps

Design of a New Energy-saving Hydraulic Pumping Unit with Variable Speed Control and Closed Oil Circuits

Design of Contra-Rotating Waterjet Pump Based on High Cavitation Performances

Design of a High Speed Internal Gear Pump to Increase the Power Density of Electro Hydraulic Actuators (EHA) in Mobile Applications

Design Method of Water Jet Pump Towards High Cavitation Performances

New Method to Determine the Dynamic Fluid Flow Rate at the Gear Pump Outlet

The Design and Analysis of a Hydro-Pneumatic Energy Storage Closed-Circuit Pump Control System with a Four-Chamber Cylinder

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Leakage and Volumetric Efficiency Analysis and Seal Improvement of Internal Gear Pump with Multi Output