Abstract:The visualized cavitation experimental apparatus is designed and constructed. The cavitation evolution process is recorded by high‐speed photography. The evaporation and condensation coefficients are modified based on experiments. The cavitation damage region is predicted by the gas‐phase condensation rate.For the phenomenon of widespread and serious cavitation damage in the throttling section of pressure reducing valve under high temperature and high pressure in the chemical technology process of petroleum and coal, according to actual coordination structure widely applied between the valve core and valve seat, the cavitation throttling section with symmetrical contraction and expansion was made, and the visualized cavitation water tunnel experimental apparatus was designed and constructed. The cavitation evolution process with time under different cavitation numbers σ was recorded by the high‐speed photography, the variation law of cavitation damage length and area with time was investigated by using aluminum film as cavitation damage carrier. Based on the experimental cavitation characteristic length L*, the evaporation coefficient Fv, and condensation coefficient Fc in the Zwart–Gerber–Belamri cavitation numerical model were modified, and the cavitation damage region was predicted by the gas phase condensation rate of numerical simulation. The results show that with the decrease of cavitation number, the characteristic length of cavitation strip increases; the cavitation characteristic length fluctuates greatly at σ = 1.22, and there are cavitation cloud periodic formation, shedding, collapse, and disappearance at the tail of the cavitation strip on the upper valve seat; the cavitation damage length of the upper and lower valve seat remains unchanged with time, and the cavitation damage area increases approximately linearly with time; the initial position and length of cavitation damage predicted by the gas phase condensation rate are basically consistent with the experimental results, which verifies the accuracy of the modified numerical simulation.

Inhibition mechanism of bionic drainage hole on cavitation flow in the regulating valve

Parameter cooperative matching optimization method for anti-cavitation structure of unloading valve

Cavitation Effect on Flow Resistance of Sleeve Regulating Valve

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

Transient Study Of Flow And Cavitation Inside A Bileaflet Mechanical Heart Valve

Cavitation Suppression of Bileaflet Mechanical Heart Valves

Effect Mechanisms of Leading-Edge Tubercle on Blade Cavitation Control in a Waterjet Pump

Experimental study on cavitation inhibition in a butterfly valve with different plate shapes

A comprehensive review of cavitation in valves: mechanical heart valves and control valves

A Parametric Study of Hydrodynamic Cavitation Inside Globe Valves

Experiment and numerical simulation investigation on cavitation evolution and damage in the throttling section of pressure reducing valve

Numerical Investigation Of Methodologies For Cavitation Suppression Inside Globe Valves

Numerical Study of Porous Tip Treatment in Suppressing Tip Clearance Vortices in Cavitating Flow

The Flow and Cavitation Characteristics of Cage-Type Control Valves

Numerical Analysis of Flow and Cavitation Characteristics in a Pilot-Control Globe Valve with Different Valve Core Displacements

Experimental studies of cavitation evolution through a butterfly valve at different regulation conditions

INVESTIGATION INTO CAVITATION INDUCED NOISE WITHIN HYDRAULIC RELIEF VALVE

Influence of inlet pressure on cavitation characteristics in regulating valve

Effect of valve core shapes on cavitation flow through a sleeve regulating valve

Effects of Throttling Windows on Cavitation Flow of Sleeve Control Valve

Effects of Sleeve Parameters on Cavitation Control Performance in Steam Trap Valves