Abstract:The Journal of Strain Analysis for Engineering Design, Ahead of Print. In the present work, the process chain in tube production by roll forming of the steel 34MnB5 was examined in more detail. The process chain consisting of the steps (i) roll forming, (ii) HFI welding, and then (iii) straightening and final calibration was mapped using the finite element method. In addition to the pipe geometry, the residual stress distribution was considered as an essential target value for the assessment of the performance of the tubes under service conditions. The objective of the project is to describe the manufacturing process and thus the processing induced residual stress distributions as realistically as possible. For a more detailed characterization of the process and above all for the validation of the numerical simulations, experimental residual stress analyses were carried out for the final state of the tubes using complementary analysis methods. The contour method was used to determine the 2D-distribution of residual stresses across the transverse and longitudinal sections of the manufactured pipes. These measurements were supplemented by local residual stress analyses using the incremental hole drilling method and X-ray residual stress analyses. The work thus pursues both a methodical approach to the analysis of the internal stresses induced by the process using complementary methods and also a manufacturing approach to the analysis and evaluation of the production chain. In particular for the axial components of the residual stresses, it can be shown that experimentally determined residual stresses correlate well with the numerically calculated values. The contour method is excellently suited to monitor the uneven distribution of the internal stresses over the pipe cross-section. The results of the simulation show that the overall residual stress distribution that is determined using the contour method mainly results from the plastic strains introduced by the roll forming process. X-ray and hole drilling analyses are shown to be more suitable for measuring locally present residual stresses at defined positions on the outer tube surface. In this way it can be shown that the simulation approach described provides an accurate model of the process.

Residual Stress Measurements in Tensile Armours of Flexible Pipes by the Contour and X-Ray Diffraction Methods

Depth-sensing Indentation Measurement and Finite Element Analysis of Residual Stress Field Near Fatigue Crack Tip

Use of instrumented indentation testing to study local mechanical properties of 304L SS welded joints subjected to low-cycle fatigue loadings

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

Depth-Sensing Indentation-Based Studies of Surface Mechanical Behavior and Fatigue Damage Evolution of an Austenitic Stainless Steel Subjected to Cyclic Straining

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Development and comparison of residual stress measurement on welds by various methods

Residual stress management: Recent advances in engineering methods for non-destructive measurement and beneficial redistribution of residual stresses

Residual stress measurement of Inconel 600 on different welding techniques by using conventional and XRD methods

Investigation of the residual stress distribution in repairs in H13 steel by friction hydro pillar processing

Residual Stress Measurement Techniques for Metal Joints, Metallic Coatings and Components in the Railway Industry: A Review

Diffraction-Based Residual Stress Characterization in Laser Additive Manufacturing of Metals

Correlation of Tensile Deformation-Induced Strain in HSLA Steel with Residual Stress Distribution

Recent Progress in Residual Stress Measurement Techniques

Technology development for in-situ measurement of residual stress in arc welded joints of MDN 250 by portable Cosα X-ray diffraction method

Experimental and numerical analysis of residual stresses induced by the manufacturing process of longitudinal welded tubes

RESIDUAL STRESS OF WELDED I SECTIONS FABRICATED FROM HIGH PERFORMANCE STEEL: EXPERIMENTAL INVESTIGATION AND MODELLING

Characterization of Mechanical Properties and Residual Stress in API 5L X80 Steel Welded Joints

Residual-Stress, Material Characterization in P22 HRSG-Pipeline Butt Joint

Recent progress of residual stress measurement methods: A review