Abstract:Solid electrolytes are considered a potentially enabling component in rechargeable batteries that use lithium metal as the negative electrode, and thereby can safely access higher energy density than available with today's lithium ion batteries. To do so, the solid electrolyte must be able to suppress morphological instabilities that lead to poor coulombic efficiency and, in the worst case, internal short circuits. In this work, lithium electrodeposition experiments were performed using single-crystal Li6La3ZrTaO12 garnet as solid electrolyte layers to investigate the factors that determine whether lithium penetration occurs through brittle inorganic solid electrolytes. In these single crystals, grain boundaries are excluded as possible paths for lithium metal propagation. However, Vickers microindentation was used to introduce sharp surface flaws of known size. Using operando optical microscopy, it was found that lithium metal penetration sometimes initiates at these controlled surface defects, and when multiple indents of varying size were present, propagates preferentially from the largest defect. However, a second class of flaws was found to be equally or more important. At the perimeter of surface current collectors, an enhanced electrodeposition current density causes lithium metal filled cracks to initiate and grow to penetration, even when the large Vickers defects are in close proximity. Modeling the electric field concentration for the experimental configurations, it was shown that a factor of 5 enhancement in field can readily occur within 10 micrometers of current collector discontinuities, which we interpret as the origin of electrochemomechanical stresses leading to failure. Such field amplification may determine the sites where supercritical surface defects dominate lithium metal propagation during electrodeposition, overriding the presence of larger defects elsewhere.

Initiation of dendritic failure of LLZTO via sub-surface lithium deposition

In situ Observation of Li Deposition‐Induced Cracking in Garnet Solid Electrolytes

Heterogeneous Doping via Nanoscale Coating Impacts Mechanics of Li Intrusion in Brittle Solid Electrolytes

Preparation of transparent LLZTO electrolyte and its application in the observation of Li dendrite

Understanding the origin of lithium dendrite branching in Li6.5La3Zr1.5Ta0.5O12 solid-state electrolyte via microscopy measurements

Accelerated Li Penetration and Crack Propagation Due to Mechanical Degradation of Sulfide‐Based Solid Electrolyte

(Invited) Chemomechanical Phenomena During Lithium Metal Plating

Failure Analysis of Garnet-Type Solid State Electrolyte LLZO by Electrochemical Method

Visualizing plating-induced cracking in lithium-anode solid-electrolyte cells

The Role of Local Inhomogeneities on Dendrite Growth in LLZO-Based Solid Electrolytes

Investigation of in-situ lithium dendrite growth in the garnet type electrolyte Li7-xLa3Zr2-xTaxO12 (LLZTO) under an applied DC voltage

Lithium Metal Penetration Induced by Electrodeposition through Solid Electrolytes: Example in Single-Crystal Li6La3ZrTaO12 Garnet

Linking the Defects to the Formation and Growth of Li Dendrite in All‐Solid‐State Batteries

Direct Observation of Lithium Dendrites Inside Garnet-Type Lithium-Ion Solid Electrolyte

In-situ optical observation of Li growth in garnet-type solid state electrolyte

Perspectives on Li Dendrite Penetration in Li7La3Zr2O12‐Based Solid‐State Electrolytes and Batteries: Materials, Interfaces, and Charge Transfer

Deflecting Dendrites by Introducing Compressive Stress in Li7La3Zr2O12 Using Ion Implantation

Perspectives on Li Dendrite Penetration in Li<sub>7</sub>La<sub>3</sub>Zr<sub>2</sub>O<sub>12</sub>-Based Solid-State Electrolytes and Batteries: Materials, Interfaces, and Charge Transfer

High-throughput dynamic modeling of Li migration behaviors in garnet electrolyte

Lithium Dendrite Propagation in Ta-Doped Li 7 La 3 Zr 2 O 12 (LLZTO): Comparison of Reactively Sintered Pyrochlore-to-Garnet vs LLZTO by Solid-State Reaction and Conventional Sintering

Grain Boundary Characterization and Potential Percolation of the Solid Electrolyte LLZO