Abstract:The complex interaction between turbulence and the free surface in boundary layer shear flow created by a vertical surface-piercing wall is considered. A laboratory-scale device was built that utilizes a surface-piercing stainless steel belt that travels in a loop around two vertical rollers, with one length of the belt between the rollers acting as a horizontally-moving flat wall. The belt is accelerated suddenly from rest until reaching constant speed in order to create a temporally-evolving boundary layer analogous to the spatially-evolving boundary layer that would exist along a surface-piercing towed flat plate. Surface profiles are measured with a cinematic laser-induced fluorescence system and sub-surface velocity fields are recorded using a high-speed planar particle image velocimetry system. It is found that the belt initially travels through the water without creating any significant waves, before the free surface bursts with activity close to the belt surface. These free surface ripples travel away from the belt before appearing to become freely-propagating waves. From sub-surface velocity measurements, it is found that close to the surface, transition to turbulence happens sooner than far from the surface, leading to an overall thicker boundary layer in the vicinity of the free surface. A secondary peak in streamwise velocity fluctuations accompanies this transition to turbulence and this peak reaches a maximum value a short time later before smoothing outward. Using momentum thickness as a length scale and the streamwise velocity fluctuations at the location of this outer peak as a velocity scale, free surface bursting and air entrainment onset are found to depend in some way on Weber number and agreement is found with scaling arguments for air entrainment presented by Brocchini and Pregrine (J. Fluid Mech., 499, 225-254, 2001).

A resolvent analysis of the effect of passive perforated surfaces on wall-bounded turbulence

Frequency-tuned surfaces for passive control of wall-bounded turbulent flow – a resolvent analysis study

Effects of Wall Transpiration on the Supersonic Boundary-Layer Oblique-Type Transition

Direct Numerical Simulations of First-Mode Oblique Breakdown in a Supersonic Boundary Layer under Wall Transpiration

Turbulent Boundary Layer over Porous Media with Wall-Normal Permeability

Enhanced micro-perforated wall-treatments for reducing the boundary layer noise in a low-speed wind-tunnel: modelling, characterization and optimization studies.

Near-wall turbulence alteration with the Transpiration-Resistance Model

Analytical study for oblique wave interaction with a submerged horizontal perforated plate near a partially reflecting vertical wall

Coupled dynamics of wall pressure and transpiration, with implications for the modeling of tailored surfaces and turbulent drag reduction

Amplitude modulation in turbulent boundary layer over anisotropic porous wall

Cost-efficient characterization of the aeroacoustic performance of micro-perforated wall-treatments in a wind tunnel

Wall Boundary Conditions for RANS Modelling of Unidirectional and Oscillatory Boundary-Layer Flows

Permeability and turbulence over perforated plates

Effect of near-wall treatments on airflow simulations

Turbulent flows over porous lattices: alteration of near-wall turbulence and pore-flow amplitude modulation

Transport of Turbulence Across Permeable Interface in a Turbulent Channel Flow: Interface-Resolved Direct Numerical Simulation

Reynolds number dependence of turbulent flows over a highly permeable wall

Near-Surface Boundary Layer Turbulence Along a Horizontally-Moving, Surface-Piercing Vertical Wall

Receptivity of compressible boundary layers over porous surfaces

A systematic study of turbulent heat transfer over rough walls

Wall pressure control of a 3D cavity with lateral apertures and wall proximity