Abstract:The micro-mixing combustor exhibits the advantages of rapid and uniform mixing of fuel and air, high safety, and low emissions, showing broad prospects in the utilization of hydrogen energy. The micro-tube serves as a fundamental unit of the micro-mixing combustor. This paper places emphasis on the mixing mechanism of hydrogen and air in the micro-tube, conducting a thorough analysis of the mixing phenomena in micro-tubes with different geometric configurations using the large eddy simulation (LES) method. When employing the fuel single-hole vertical injection structure, the micro-tube jet in cross-flow (JICF) generates vortex structures similar to those in open-space JICF. The counter-rotating vortex pair (CVP) plays a crucial role in the mixing process, but its mixing ability in the jet direction is not strong enough, leading to lower fuel concentration near the wall and increased mixing deficiency. At higher fuel injection speeds, the fuel jet impacts the wall and wraps around it, enclosing the air and promoting mixing. Increasing the number of fuel holes to 2, under constant speed ratio, results in a phenomenon of mutually opposing fuel jets, squeezing the fuel to the sides of the micro-tube. This enhances the local near-wall fuel concentration and reduces mixing deficiency. However, when using 3 or 4 fuel holes, the jets no longer oppose due to reduced penetration depth, and poor diffusion of fuel near the wall remains the main reason for mixing deficiency. To improve near-wall fuel concentration, structures with the jet at a certain angle to the diameter are studied. Under the influence of the wall, CVP evolves into a single vortex, and the fuel rotates along the wall. When the jet is inclined at 45 degrees to the diameter, mixing deficiency rapidly decreases. It can achieve relatively ideal mixing effects, with fuel and air uniformly mixed downstream of the fuel hole at approximately 15 times the tube diameter.

Optimization of Flow and Mixing in a Venturi Tube Mixer with a Two-Step Method Using Numerical Simulation

Mixing in T-shaped Micro-Channel Network

An optimal study on a TVC evaporation tube using moving particle semi-implicit method

Micro-Mixing Enhancement in a Taylor-Couette Reactor Using the Inner Rotors with Various Surface Configurations

Numerical Simulation for Effects of Venturi Tube on Swirling Flow Field

Optimization of Venturi Tube Design for Pipeline Pulverized Coal Flow Measurements

Mixing Efficiency Analysis On Droplet Formation Process In Microchannels By Numerical Methods

Numerical Simulation of the Efficiency of Mixing in Heterogeneous Microchannels with Patterned Surface Potentials

Numerical Simulation on Fluid Mixing by Effects of Geometry in Staggered Oriented Ridges Micromixers

Optimization of G1 Micromixer Structure in Two-Fluid Mixing Based on CFD and Response Surface Methodology

Experimental and Numerical Study on Flow Resistance and Bubble Transport in a Helical Static Mixer

Numerical Simulation of Power Consumption and Mixing Characteristics of Novel Large-Double-blade Impeller

Simulation of the Mixing Process in A Straight Tube with Sudden Changed Cross-Section

Numerical Simulation of Effects of Venturi Tube Throat Diameter on Flow Field of Combustor

Design Optimization Analysis of Venturi Tube for Medium Conveying in Strengthen Grinding Process

Numerical Investigation of H2/air Mixing Characteristics in Micro-Tubes with Different Geometric Configurations

Topology optimization design of micromixer based on principle of Tesla valve: an experimental and numerical study

Numerical Simulation of Internal Flow Field in Optimization Model of Gas–Liquid Mixing Device

Experiment and modeling of liquid-phase flow in a venturi tube using stereoscopic PIV

Numerical study of the mixing of micron particles in a vane mixer

Numerical Simulation and Experimental Study of Gas-solid Two-phase Flow in Venturi Tubes