Abstract:Compressible flow past a circular cylinder at an inflow Reynolds number of 2 x 10 5 is numerically investigated by using a constrained large-eddy simulation (CLES) technique. Numerical simulation with adiabatic wall boundary condition and at a free-stream Mach number of 0.75 is conducted to validate and verify the performance of the present CLES method in predicting separated flows. Some typical and characteristic physical quantities, such as the drag coefficient, the root-mean-square lift fluctuations, the Strouhal number, the pressure and skin friction distributions around the cylinder, etc. are calculated and compared with previously reported experimental data, finer-grid large-eddy simulation (LES) data and those obtained in the present LES and detached-eddy simulation (DES) on coarse grids. It turns out that CLES is superior to DES in predicting such separated flow and that CLES can mimic the intricate shock wave dynamics quite well. Then, the effects of Mach number on the flow patterns and parameters such as the pressure, skin friction and drag coefficients, and the cylinder surface temperature are studied, with Mach number varying from 0.1 to 0.95. Non-monotonic behaviors of the pressure and skin friction distributions are observed with increasing Mach number and the minimum mean separation angle occurs at a subcritical Mach number of between 0.3 and 0.5. Additionally, the wall temperature effects on the thermodynamic and aerodynamic quantities are explored in a series of simulations using isothermal wall boundary conditions at three different wall temperatures. It is found that the flow separates earlier from the cylinder surface with a longer recirculation length in the wake and a higher pressure coefficient at the rear stagnation point for higher wall temperature. Moreover, the influences of different thermal wall boundary conditions on the flow field are gradually magnified from the front stagnation point to the rear stagnation point. Moreover, the influences of different thermal wall boundary conditions on the flow field are graduallymagnified from the front stagnation point to the rear stagnation point. It is inferred that the CLES approach in its current version is a useful and effective tool for simulating wall-bounded compressible turbulent flows with massive separations.

Large eddy simulation of end effects on a cylinder rotor

Constrained Large-Eddy Simulation of Compressible Flow Past a Circular Cylinder

Numerical Simulation of three-dimensional flow around a circular cylinder of finite length

Large-eddy simulation of three-dimensional aerofoil tip-gap flow

Numerical Study of Free End Effect of Cylinder with Low Aspect Ratios on Vortex Induced Motion

Large-Eddy Simulation of the Flow Past Both Finite and Infinite Circular Cylinders at Re=3900

Effect of Lateral End Plates on Flow Crossing a Yawed Circular Cylinder

Numerical simulation of cylinder orientation through a rotating straight expansion duct

Numerical Study on the Vortex Motion Patterns Around a Rotating Circular Cylinder and Their Critical Characters

Numerical simulation of flow-induced vibration on two circular cylinders in a cross-flow (Part I: Transverse y-motion)

FUNDAMENTAL AREAS OF PHENOMENOLOGY (INCLUDING APPLICATIONS): Vortex Structures and Behavior of a Flow Past Two Rotating Circular Cylinders Arranged Side-by-Side

Simulation of Flows Around Two Tandem Rotating Cylinders in a Channel Using LB-DF/FD Method

Large-eddy simulations of flow past a circular cylinder near a free surface

Large eddy simulation of flow around the cylinders with different aspects

Numerical analyses of the flow past a short rotating cylinder

Large-Eddy Simulation and RANS Analysis of the End-Wall Flow in a Linear Low-Pressure Turbine Cascade, Part I: Flow and Secondary Vorticity Fields Under Varying Inlet Condition

Air Flow Analysis of a Rotating Cylinder through Numerical Simulation

Large-eddy simulation of the flow past a cylinder with Re=3 900

Large eddy simulation of flow past an inclined finite cylinder

Large eddy simulation of flow over inclined wavy cylinders

Experimental and numerical investigation on the wake flow and vortex shedding of a rotating circular cylinder